Factory Direct Supply 4t boiler Jordan

General Electric factory direct supply 4t boiler jordan according to the size decontamination decontamination apparatus has the following two ways: 1, in the station equipment. Decontamination station generally higher, before the device is a heater or a return pipe, in order to avoid debris flowing into the heater; 2, device in the water supply pipe outside the station. Decontamination station at the well outside the home are generally small, typically in water supply equipment, equipment and some system, some system is not the device, it is to avoid the effect of debris into the user's radiator.

ZG factory direct supply 4t boiler jordan waste heat boiler series

In recent years, various types of waste heat boilers have been sold hot. Waste heat boiler refers to a boiler that uses a waste heat from waste gas, waste or waste liquid in various industrial processes and heat generated by combustion of combustible materials to heat water to a certain temperature. The waste heat boiler can produce hot water or steam through waste heat recovery. To supply other sections for use. The waste heat utilization industry is very extensive, and the waste heat boiler is gradually infiltrating into many industries. It is a kind of energy-saving equipment with rapid development and wide application.

The Fangkuai factory direct supply 4t boiler jordan believes that the correct adjustment of the supply and draft air volume is conducive to environmental protection, and it can also save energy under certain conditions. The Fangkuai boiler can first determine the suitable value of carbon dioxide or oxygen at the measuring point above the adjustment of the supply air volume. It is then compared with the measured value to determine if the supply air volume needs to be adjusted. If the boiler and flue are running under negative pressure, the outside air will leak into the flue from the wall or door of the furnace, obviously to the back of the flue, in the smoke. The higher the value. Therefore, when monitoring the supply air volume of boiler with carbon dioxide meter or oxygen meter, the influence of air leakage before measuring point should be considered. In order to determine the appropriate value of carbon dioxide or oxygen at the test point, it is difficult for the boiler to obtain the best excess air coefficient exactly in actual operation. The general regulation is to reduce the air flow as much as possible, that is to say, the manager reduces oxygen or increases carbon dioxide as much as possible, on the premise that there is no flame, dark red instability or black smoke in the combustion. In addition to adjusting the air flow into the furnace, attention should be paid to adjusting the air distribution. Negative pressure is one of the most important operating parameters in Fangkuai boiler. In normal operation, the negative pressure at furnace outlet should be 20? 30 Pa. If the furnace negative pressure is too high, it will cause the furnace and flue If positive pressure appears in the furnace, the flame and smoke in the furnace will be sprayed out of Shanghai, which will not only affect the environmental hygiene, but also may occur personal burn accident. 3. The heat loss of exhaust gas will be increased by the increase of air leakage, and the power consumption of the induced fan will be increased, if the furnace pressure is positive, the flame and smoke in the furnace will be sprayed to Shanghai. Therefore, in the process of combustion adjustment, it is necessary to adjust the air diversion site according to the change of furnace negative pressure in order to keep the furnace negative pressure in a normal value while adjusting the fuel quantity and air supply. When the boiler increases the load, it must first increase the draft air volume, then increase the supply air volume; on the other hand, when the boiler load drops, it must first reduce the supply air volume before reducing the draft air volume. Finally adjust the furnace negative pressure to the required value. Yes There is no draft air volume adjustment problem in micro positive pressure combustion boiler. Fangkuai boiler air volume regulation is easy, can easily meet your needs, sincerely welcome you to consult and negotiate business.

Burns Hospital Affiliated Hospital of Shanxi Linfen Linfen Steel is attending a hospital burns burns and other diseases. Hot water factory direct supply 4t boiler jordan is essential hospital equipment heat, hot water output can provide disinfection of medical instruments and ward heating demand. With constantly improving our environmental policy, boiler correspondingly introduced more sophisticated Use. Linfen hospital burns to respond positively to the national environmental policy, decided to introduce an environmentally friendly low nitrogen gas hot water boiler. Taking into account the special circumstances of the hospital, the boiler should also have the use of safe, clean overall characteristics. Based on the above considerations, finalize the Linfen hospital with burns boiler party cooperation fast, fast is provided by one side of a gas condensing pressure hot water boiler (CWNS2.1-95 / 70-Y.Q).