2 tons industrial gas boiler high efficiency LPG steam boiler

In early November, Luyi County, Henan Province Quality Supervision Bureau organized a safety inspection activities on the boiler in the area, ensure the safe use within the jurisdiction of the boiler in winter.

The main focus of inspection units use boilers to see through the following points:

First, the use of registration, maintenance, periodic testing situation.

Second, the establishment and implementation of the system and the rescue plan.

Third, if the boiler worker certificates.

Fourth, the operation of the boiler water treatment facilities.

To date, Luyi County Quality Supervision Bureau has complete supervision and inspection work on 11 units in the boiler, the inspection found problems and risks, monitor the instruction issued according to the law, clearly boiler rectification matter and time.

Operating cost comparison of different fuel 2 tons industrial boiler high efficiency lpg steam boiler below Henan fast boiler with small series to introduce the company's operating cost comparison of different fuel steam boiler. Refers to a steam boiler water heated to a certain temperature parameters, and the production of industrial steam boiler, water is heated into steam in the steam drum, the fire in the furnace emits heat, it is the principle of the steam boiler. Steam boiler belongs to special equipment. Gas: Advantages: clean energy, high thermal efficiency and save costs. Disadvantages: Restricted gas on condition. Generating a cost of about 2.4 tons of steam million (calculated as the price of 3.2 yuan gas / side) fuel: steam boiler advantages: no pollution, high efficiency, no fuel limitation. Disadvantages: higher operating costs. Produce one ton of steam costs about 594 yuan (fuel prices by 9.5 yuan / kg calculated) electrical heating: advantages: no pollution, no fuel limitation. Disadvantages: is a secondary energy, high operating costs to produce one ton of steam costs about 700 yuan (electricity prices by 0.6 yuan / kWh). Coal: advantages: low operating costs. Disadvantages: pollution, restrict the use of some areas, the cost of one ton of steam produced is about 150 yuan (coal prices by 900 yuan / ton).

Boiler fire phenomenon, how to do 1, furnace pressure fluctuations or to limit and alarm. 2, no flame detector flame, flame flameless television display. 3, flue gas oxygen abnormal fluctuations. 4, steam pressure steam temperature dropped drastically. 5, furnace black, black smoke chimney. 6, the flue gas temperature is reduced. 7, MFT action, turbine trip, splitting the unit. Cause 1, the furnace combustion conditions organizations unreasonable, improper wind coal proportion. 2, the load is too low, unstable combustion conditions without oil combustion vote, or vote, although oil but not good combustion results. 3, cast oil, poor quality oil, oil spray gun is bad, low oil pressure, oil system failure. 4, poor coal quality, coal is too rough, the water is too large pulverized coal combustion adjustment is not timely. 5, the primary air temperature, air pressure is too low. 6, boiler MFT protection action. 7, a large area of ​​the furnace coke collapse, smashing off the flame. 8, severe water wall pipe explosion will blow out the flame. 9, all coal-fired condition, mill pulverizing system failure caused most or all trips. 10, a part of auxiliary machinery such as a fan, blower, fan, air preheater tripped, causing unstable furnace combustion conditions. 11, sootblowing properly, resulting in a large number of normal operation of the furnace ash effects of fire inspection of the boiler. 12, bottom seal damage. Treatment 1, the boiler fire, MFT should be action, otherwise manual MFT. 2, normal inspection device linkage linkage MFT, confirm that all fuel cut. 3. quickly identify the cause, try to eliminate the boiler can be re-ignition, the recovery unit operation. 4, when the mill started again after the trip, the trip must be the primary air tube mill full purge. 5, the MFT operation, checks, Fan normal operation, automatic furnace vent. 6, the MFT movement, check all the secondary purge air damper position is set, the total air volume is automatically adjusted to 30 ~ 40% BMCR sufficiently purged air volume. 7, the MFT operation, when the turbine is in a state disk drive, the disk drive must continue until the normal turbine eccentricity, before re turn red. 8, if temporarily unable to identify or eliminate the cause, restart and could threaten personal safety equipment, non-start. 9, processing according to the corresponding predetermined remaining MFT.

In Malaysia, there are lots of biomass fuel like palm shell and palm fiber, we recommend SZL or DHL type for using water tube boiler. If the steam capacity is less than 25t/h, the SZL will be the best choice, whereas if the steam capacity is more than 25t/h and less than 100t/h, DHL corner tube boiler could be chosen. In addition, the gas or diesel is another kind of source for the local user, so SZS type could be recommended.