Hot Selling Industrial 2t Natural Gas boiler Maldives

Temperature protection device during the fuel steam hot selling industrial 2t boiler maldives over temperature to regulate protective effect of temperature protection is an important procedure fuel steam boiler safe operation is particularly important for the regulation and protection of the boiler temperature of the fuel vapor; at the same time to regulate in the fuel steam boiler overtemperature Protective effects. Conventional boiler temperature protection means is a bimetallic temperature controller. Flame protection: prevent explosion of the furnace, steam boiler fuel flame protection means must be provided, is a function of combustion (including ignition, combustion or misfires when halfway off, typically within five seconds reignition monitoring the furnace, a second the run off into the oil (gas) solenoid valve, and turns on and audible alarm signal, when the blower continues to operate, the residual gas was purged of combustible furnace, after 20 to 30 seconds purge, automatically cut off and various auxiliary blowers supply the boiler operation stops. role is to monitor the flame signal the presence of a flame or an interrupt control apparatus mainly using a photomultiplier tube, a photovoltaic cell and photosensitive resistance, they have an infrared type or ultraviolet type a photoelectric conversion element, the working principle of the light converted to the corresponding strength of the radiation strength of current and the linear output state, sometimes weak induction current, through amplification, in order to have an effect on the controller.

The transformation of low nitrogen hot selling industrial 2t boiler maldives should be noted that what matters for retrofitting low nitrogen boiler should be noted that what? Of nitrogen oxide emissions is large, complex sources, environmental problems caused by acid deposition, fine particles, ozone, nitrogen oxides and analysis of contamination status must be further strengthened. If you do not take further measures to reduce emissions, with the United States and the United States to speed up economic development, population growth and urbanization, nitrogen oxide emissions will continue to grow in China in the future. Based on current trends, by 2030, emissions will reach 35.4x106 tonnes, will inevitably cause serious environmental impacts. Therefore, we must effectively enhance the emission control of nitrogen oxides. From this we can see that low nitrogen boiler is imperative! A check device to check for low NOX combustion gas before commissioning is in place, the gas pipeline flow is clean, whether the valve is open. There is a burner pipe leaks, reasonable pipeline installation. Discharging vent pipe valve from the foregoing, to ensure that no mixing of the air duct, and the exhaust pipe should be connected to the outdoor. Second, stable combustion and combustion of homeostasis Remember, combustion adjustment is the basis for all of the low nitrogen burner adjustment, as long as guaranteed under any changes in operating conditions of combustion stability and combustion of dynamic equilibrium, to burn steam temperature influence is even greater. Since the steam temperature is a sign flue gas heat value balance between the steam and heat absorption, this can be maintained as long as the dynamic balance, steam temperature can be kept stable. Third, the level of flame boiler boiler central flame center is also an important factor in high impact low-temperature steam. In the high temperature steam operation, the amount of coal combustor exhaust can be reduced, the amount of the lower stage burner of coal may be increased, and vice versa. Running low nitrogen burners, it should also be noted effect of different combinations of temperature steam mill. Steam at a low temperature exhaust composition regulating a large margin, the combination of the high temperature exhaust temperature adjusting stage so small margin overheat. It should be strengthened and soot blowing air distribution according to the situation.

After the hot selling industrial 2t boiler maldives high cost of it? That renovation work is currently boiler have been carried out in various provinces and cities, many users are willing to transform doubt there will be a point, that is the high cost after the boiler yet? Then we took the coal-fired gas boiler renovation project for analysis. During the transformation of the former coal-fired boilers, there will be some need for coal storage, transportation costs, low operating efficiency of the boiler, the boiler thermal efficiency loss, loss of fuel costs caused by production costs caused by the loss of non-compliance; Then there will be coal-fired processing costs pollutant emissions boiler; and a lot of maintenance costs and labor costs continue to treat boiler site troubleshooting, and accounting of these costs are relatively high. After that say transformation, gas boilers belong first and foremost clean energy, to some extent, less waste emissions, it will save some gas treatment costs; In addition, the auxiliary gas boiler system more orderly is not complicated, so the run is relatively stable , operating efficiency is relatively high, so will enhance the operational boiler thermal efficiency to a certain extent, there is some improvement on return loss and the cost of fuel; at the same time, gas boiler this would not take up space, just to ensure perimeter clean can be, relatively speaking, save some labor costs, probably in terms of fuel, natural gas will be slightly more expensive than some of the coal, but the longer term, energy-saving effect of natural gas boilers, will be a period of time, return this part of the difference in money, but if management properly, will reach back to the results. After so the cost after the boiler strictly speaking, is not elevated, a certain time, will achieve cost reduction.

Food is food industry is human life industry, but also an ancient and eternal evergreen industry. Industrial steam hot selling industrial 2t boiler maldives as an integral part of the chain, is mainly used for processing of distillation, extraction, sterilizing, drying, curing and other processes. Anqing City, Anhui Province is located in the Want Want Foods Co., Ltd. mainly engaged in all kinds of puffed food processing and manufacturing and sale of steam boiler steam delivered directly or indirectly in contact with food, thus requiring the steam quality is very high. Due to expanding production needs, Want Want Foods in urgent need of a boiler plant to provide high-quality steam. After a comprehensive understanding of the boiler industry, determined to cooperate with the fast boiler. Want fast square perennial cooperation with the country's food company, it has considerable experience of cooperation. By understanding the needs of the Want Want food production, providing a whole 10 tons of steam condensing gas steam boiler (WNS10-1.25-Y.Q).