Cheap 6t Natural Gas boiler Georgia

2, tightness test

Indoor gas boiler pipes tightness test should be consistent with the following requirements:

① low pressure gas pipe test pressure boiler for planning a pressure not less than 5kPa, under the experimental pressure regulator least 30min, and view all the joint with the blowing agent, no leakage, no pressure gauge pressure drop qualified equipment. When the experimental system stainless steel corrugated hose, plastic composite pipe, oil hose, when the plastic cover brass, IH pressure not less than the experiment, in addition to sealing the respective view point, the end surface of the cladding layer should also whether there is leakage phenomenon View.

② medium pressure gas pipelines boiler pressure test planning more pressure and not less than 0.1Mpa. Under the experimental pressure regulator less than 2h, and view all joints with a blowing agent, no leakage, no pressure drop pressure measurement device qualified.

Since I began preparations for the 2018 ASME certification program, and at the beginning of the project preparation work since January this year, the project has entered a crucial stage of the implementation. Ms. Jiang Lianju quality system under warranty division led to ASME certification were careful overall planning work to develop a detailed plan of the evidence, and careful organization departments to participate in the work of the various stages of implementation.

WNS is automatic gas (oil) parameters commonly used cheap 6t boiler georgia. Where each letter implication is that

W: horizontal. A boiler according to the design and installation of the outer layout, was lying state. An exhaust gas stream produced by the boiler is of horizontal flow, the flow of hot gas, in the same section on the exhaust gas temperature is low compete.

WNS oil gas fired horizontal steam cheap 6t boiler georgia

Trust The horizontal boiler Experts at ZG Boiler