High Efficiency Fully Automatic coal steam boiler Singapore

We have long known that fast boiler this brand, high-tech enterprises in Henan Province, the most influential brand, technology entrepreneurs contribution to enterprise and many other honors, so that our brand is very interested in each other fast. Through this collaboration, proving once again that our decision is not wrong, 15 tons of steam condensing gas boiler provides steam to fully meet the needs of our dairy products processing plant. --customer feedback

Check Item item hot water boiler hot water boiler comprising a boiler inspection and checking internal use preparations, checking in the furnace and the flue, the boiler attachment check, check automatic control system, the secondary device, check the combustion device, the auxiliary heat check the surface of the hot water boiler must be done before running some tests, these tests are quite a lot of us, it is possible because of our neglect and causing very serious consequences. Therefore, we must forestall, be sure to carefully check the following before the hot water boiler operation. 1, including the use of internal inspection and boiler ready. 2, inspection, and furnace fouling and debris inside the flue in the furnace and flue should be cleaned. Flue duct and damper, the shutter must be complete and compact, flexible switch, opening and closing accurately indicated. 3, check the boiler accessories, check the safety accessory is intact; cock is rotating flexible, easy to use; all kinds of instruments and controls should be complete, good, clean. After passing the examination, should the gauge cocks in working condition. 4, check the automatic control system. 5. Check the accessory device. 6, inspection of the combustion apparatus, the combustion apparatus is intact inspection; mechanical transmission system, coal handling system, the ballast system test switch normally; spring-loaded safety level of a gearbox should be appropriate, well lubricated; coal shutter indicate the correct scale. iron eagle neat, well, turn the ballast plates full, flexible movement. 7, the auxiliary heating surface of the inspection, check the auxiliary device (fan, blower, pump, etc.) are firmly connected coupling; proper belt tension triangle; oil should be good enough; cooling water flow. After passing the examination, installed security guard, respectively, commissioning, and note the current when idling. It is fed out of the hot water boiler heat equivalent to a mass per hour (usually expressed in tons) in water was heated from 20 ℃ and heat output of all vaporized into a high efficiency fully automatic coal steam boiler singapore water absorbed three expressions, in tons) water from 20 ℃ heated and vaporized into all heat absorbed by the steam boiler it is fed out of the hot water heat equivalent to a mass per hour (i.e. typically kcal / hr (kcal / h), tonnes / hour (t / h ), megawatt (MW). (1) kcal / h is in metric units of expression, which represents the heat of hot water boiler fed out per hour. (2) t t borrowed steamed steam boiler popular argument, ( 3) megawatts (MW) is the international system of units unit of power, the basic unit is W (1MW = 106W). this expression formal documents should be used.

A number of national influence energy consumption high efficiency fully automatic coal steam boiler singapore coal to natural gas has been vigorous work, it should be transported steam boiler, very big eliminate the dust pollution, discharge of toxic gases and secondly nitric oxide, also got curb. Energy consumption is crucial mark measuring steam boiler, a good start and that is that work together to explore under the influence of a number of cases the energy consumption of steam boilers. Through the investigation of the persons concerned, the loss of heat from steam boilers bear the main two areas: combustion air-fuel ratio does not smoke emissions standards-related heat loss. Reduction of heat loss will install smoke emission in the flue gas heat recovery steam boiler terminal fitting, or should be transported more leading type condensation recovery boiler. Combustion air-fuel ratio standard fault summary: a conventional steam boiler burner ejector type, formed air-fuel ratio can not occur motorized adjustment. Some of the steam boiler with a mechanical blower burner, causing air-fuel ratio standard there are several aspects later: the main air-fuel ratio standard case encompass fall into two categories: air flow when exceeded, there will be an endless excess cold heat transfer, resulting in high energy cost of steam boilers, steam boilers reduced energy consumption; when the airflow is not enough, will have not exactly lit, the energy consumption caused by steam boiler weakened.

Gas boiler refers to a container for generating steam and hot water from natural gas(Calorific value 10000 kcal/Nm³), LPG(Calorific value 22929 kcal/Nm³), artificial gas(such as city coal gas, Calorific value 3000-4000 kcal/Nm³), biogas(Calorific value 5200-6000 kcal/Nm³) and other fuels. In general, gas boilers are usually packaged boilers.