Such as food processing hot water fire tube boiler price load increased, but also to ensure the boiler load unchanged or decreased in order to prevent pressure shall increase the amount of fuel and air supply, strengthen the burning, causing the furnace exit flue gas temperature of the flue gas volume increases and lower water temperature , temperature increase; If the oil and gas fuel is combusted in the furnace carbon black is not fully formed, into the superheater flue causing secondary combustion, but also greatly increase the superheat temperature. Reducing the temperature of the main reasons: improper adjustment of combustion, low flame center furnace; superheater area is small, or too much leakage at the furnace wall; Save water flow rising or temperature reduction; drum water level or high gas-water separator separating efficiency is lowered, the humidity of the vapor is increased; superheater tube fouling, reduced heat absorption and the like.

Tail secondary combustion flue how to deal with the phenomenon of a sharp increase in rear of the food processing hot water fire tube boiler price flue secondary combustion flue temperature location and later. 2, the furnace, the flue abrupt change in negative pressure, flue gas is not tight at the smoke, the Mars. 3, air preheater large current swing bearing housing temperature, severe Jam occurs. 4, air preheater fire alarm issue. 5, steam temperature, economizer outlet water temperature, the air temperature rises abnormally. 6, induced draft fan vanes automatically open a large, Fan current rise. 7, as the combustion side, both sides of the smoke temperature difference increases. Reason 1, through the coarse fine grinding coal, coal poor uniformity, improper adjustment of combustion, combustion of fuel is insufficient, serious mechanical incomplete combustion, and high levels of combustible ash accumulated in the back pass. 2, an oil burner or an oil poor atomization, so that unburned droplets deposited in the flue. 3, prolonged low load operation of boiler, the furnace temperature is too low or too small amount of excess air resulting in incomplete combustion of coal or oil accumulated in the tail. 4, after the shutdown of the fuel leakage into the furnace and accumulates or after shutdown and to insufficient MFT furnace purge unburnt coal or oil accumulation at the end of the tail. 5, soot blower failure, long-term put into operation is not normal. 1 process, when a slight secondary combustion, exhaust gas temperature does not rise within 20 ℃ normal smoking temperature should be checked immediately paragraphs, the combustion site and judge whether the secondary steam soot blowing. (When the exhaust gas temperature rises to 250 ℃) 2, the operation of the back pass and then generating boiler combustion boiler operation should be stopped immediately, immediately stop sending, ID fan and turn off all the smoke and steam soot blowing air damper fire. 3, if the economizer afterburning, until the storage tank level control valve blocking off without pressure, flow rate of feed pump motor start 150t / h Sheung be cooled. 4, air preheater heating surface of the secondary combustion air preheater normal operation, normal operation of the air pre-heater holder; air preheater Jam occurs, the main drive motor and the auxiliary drive motor trip, contact maintenance manual plate moving continuous air preheater rotor. Soot blowing steam into air preheater for extinguishing, into the air preheater for fire extinguishing can not be extinguished. 5, the economizer outlet water temperature close to the inlet temperature (at the economizer secondary combustion), the air preheater inlet gas temperature, exhaust gas temperature, the hot air temperature is lowered to less 80 ℃, each one hole, and the hole is no longer Mars smoke and soot blowing steam stops coming out after water or fire. Open hole inspection manhole and inspection to confirm the secondary combustion goes out, after the flue vent door open to drain water inside the smoke flue opening for ventilation air damper. 6, to be re-combustion is resolved, the flue temperature does not rise and fall when stabilized, before slow regulation of the air, smoke baffle, the necessary air cooling and purging.

Chinese wine culture has a long history, wine blend. In the process of making wine, almost all wine prices are inseparable from the brewing process steam, we can say the stability and quality of steam purity of the wine production plays a decisive role. Lefort Wine has been committed to producing high-quality wine products, December 2016 No. 1, Lefort wine and I signed a one 4 tons of steam condensing steam food processing hot water fire tube boiler prices, the company continues to provide high-quality wine work steam.

What power plant food processing hot water fire tube boiler price system includes: a power plant boiler pressure part of the boiler, burner equipment parts, accessories instrumentation and ancillary equipment. 1, "pressure part of the boiler" comprising: economizer, the drum, the downcomer, water wall, superheater and reheater, and soft drinks JOINT Unicom pipes, fixed and suspended boiler parts, heating surface, the furnace wall and other equipment, such as architecture. "Combustion Devices" section: the furnace, combustion equipment, air preheater, a flue and duct like. 2, the auxiliary system comprising: a fuel supply system, coal preparation systems, water systems, ventilation systems, dust removal systems ash, soot blowing system, a water treatment system, measurement and control system and a flue gas desulfurization system. Each of the auxiliary systems are equipped with the appropriate accessories and control devices. 3, combustion system