2t Energy Saving Fully Automatic boiler Bhutan

Fang Group R & D center was officially opened fast approaching New Year party quickly ushered in a large group wedding - R & D Center was officially launched. VIP dealers from Beijing, Tianjin, Hunan, Sichuan, Fujian, Heilongjiang and Xinjiang invited to participate in the ribbon-cutting activities.

4 tons of gas hot water 2t energy saving fully automatic boiler bhutan should be equipped with big water tank? One of the hot water boiler auxiliary tank is essential, then, depending on the tonnage of the boiler, the required tank size is not the same. Boiler tank for storing substantially demineralized water and oxygen. If that is a gas hot water boiler 4 tons, and return water temperature of 95/70 to count, fill water in the proportion of 3% to count, in substantially the desired size of about 3 cubic tanks, of course, based on the actual situation may be nudging up a certain number of cubic meters. In addition, four tons of gas hot water boiler with tank carrying, in addition to concerns tank material, but also pay attention to the water tank for regular checks to avoid the water tank leaks and other anomalies in the process of long-term use, the boiler operation unnecessary disruption. Meanwhile, the water into the tank should also be softened to ensure that water quality standards, in order to avoid post-precipitation of impurities caused by corrosion of the tank and impurity precipitation and other phenomena.

Treatment squib superheater tube 1, a slight rupture superheater tubes, can be appropriately reduced load, to maintain operation within a short time, this time should be closely monitored leak situation, at the same time, rapid start standby 2t energy saving fully automatic boiler bhutan. If monitoring the situation worse, should be shutdown as soon as possible. 2, when the hose rupture severe superheater must be emergency stop.

Hot water 2t energy saving fully automatic boiler bhutan water level changes in the steam pressure, steam temperature fluctuations, even full of water or water accident. Therefore, the boiler in operation should be continuous so that a balanced water supply. Or ground water supply, water supply less, in order to maintain the normal water level in the water level fluctuates slightly line. Usually the normal water level in the middle of the boiler water level. In operation it should be adjusted with the magnitude of the load: low load, higher level; high load, lower level.