gas type hot water boiler

For a large hotel, type hot water boilers are a good choice for supplying hot water for the entire hotel bath. Oil and gas hot water boilers are widely used in this kind of occasion. Recently, CBM once again exported to a wns oil and gas hot water boiler in Mexico to provide demand for a hotel. Gas fired hot water boilers have a short production and installation cycle, which saves the company some unnecessary costs due to excessive time. The wns produced is small in size and does not occupy too much space. It is easy to install and has a high degree of automation. This saves many labor costs, plant costs and learning costs. And oil and gas hot water boilers use natural gas, oil, biogas and other fuels as fuel, which is clean, does not need to store fuel, low noise, and no dust is very suitable for providing hot water for the hotel.

7MW YQW series gas-fired thermal oil heater for chemical industryAs one piece of important equipment for the water purification material production line, the thermal oil heater plays the role of providing heat energy in the production process of the water purification agent. Chongqing Lanjie Guangshun Water Purification Materials Co., Ltd. was established in 2009, mainly producing and selling industrial water chemical treatment agents and urban sewage chemical treatment agents. With the continuous expansion of production scale, the company urgently needed to upgrade the boiler equipment on the existing production line. Meanwhile, in the face of increasingly severe environmental pressures, the company decided to purchase environmentally friendly thermal oil heater which uses clean energy natural gas as fuel. In the market research process, the project manager of the company found that the ZOZEN thermal oil heater had outstanding advantages in terms of product quality, performance and environmental protection effects, then the company decided to purchase a set of 7MW horizontal gas-fired thermal oil heater from ZOZEN. This kind of heater adopts three pass circular tube design for sufficient heating surface, and the waste heat boiler and energy-saving device disposed at the tail of the heater can greatly reduce the loss of thermal energy, the thermal efficiency can be as high as 95% or more. Advanced low NOx burner can achieve NOx emissions below 30mg/Nm³. And the operation of the thermal oil heater can realize full automatic control, and can automatically adjust the combustion, high tank level, outlet temperature and flow to ensure the safe operation.

Stoke coal-fired type hot water boiler operating temperature range of its coal-fired hot water boiler, which operate in Stoke on what specific requirements will be? Its internal plumbing, how much temperature is generally able to withstand? And coal-fired hot water boiler hot water, whether it is secondary energy? These are associated with coal-fired boilers hot water boiler, so the following to explain the good answer, I hope that everyone in to get what you want. 1. Stokes fired hot water boiler operating requirements (1) before Stoke, first baffle opening smoke wind boiler, let the natural ventilation, the time is about 10 minutes. If mechanical ventilation is employed, then over time, for about 5 minutes. In this manner, the boiler furnace and combustible flue gas remaining in the exhaust clean. (2) For the boiler fire, it is strictly prohibited the use of volatile oils, to avoid problems. For Stoke-speed coal-fired hot water boiler, attention can not be too fast, in general, is not less than half an hour. Also, before Stoke, should open the circulating pump, so the job. 2. coal-fired hot water boiler interior water pipes, on the temperature, how many can afford to live? For coal-fired hot water boiler pipes inside this kind of boiler, it could afford, in general, hundreds or thousands of degrees is no problem. And it's also related to the boiler pressure. If the pressure is higher, the higher the temperature in the boiler furnace, so that the internal water circulation faster. 3. coal-fired hot water boiler, hot water, whether it is secondary energy? Coal-fired hot water boiler hot water, which belongs to secondary energy. This is because the secondary energy, which can also be called secondary energy, or artificial energy, primary energy is converted to a processed or derived, such as gas, coke, gasoline, heavy oil and steam and hot water. So, the question, the answer is yes. For coal-fired hot water boiler, the question raised above, as well as specific answers given, so that everyone can be a comprehensive knowledge and understanding of this kind of boiler, so as to carry out well the practical application of their work, and add some expertise. Furthermore, the use of effects and use value of the product to be improved.

Beiqi Panther car 6 tons of steam condensing one fuel gas steam boiler project has been successfully completed. This series boiler adopt advanced design concepts, using the waste heat of flue gas cascade, with the use of the condenser and the economizer fully absorb the waste heat in the flue gas, the boiler efficiency has been greatly improved.