2t gas boiler Factory Price Industrial Cambodia

Heard so much about fast 2t boiler factory price industrial cambodia made a number of achievements in the areas of clean boiler, this time my unit and quick cooperation parties, give me your company's boiler unit is in line with the requirements of our team boiler, to achieve a clean, energy-saving, environmentally friendly way of heating . Moreover, your company for the Beijing authorities have provided more office cleaning boilers, a good reputation. So, we finally reached a cooperation. --customer feedback

Primary air tube blockage is what causes? How to prevent? Reason: 1) blocked or coked-burner fire nozzle inlet is blocked portion of small oil gun and other debris. 2) too many impurities coal, powder machine speed is too high, the pulverized coal and primary air speed too low. 3) powder machine speed is too high, too much under the powder without timely blown away. 4) a low pressure (throttle open or not to open too small), can not take away meal. Precautions: 1) to the powder and the rotational speed of the unit load and adjust relevant primary pressure according to the powder not more than 700 rpm rotation speed, a wind speed of each holding 25 ~ 30m / s, the mixed primary air temperature was controlled at 180 to 250 ℃, a pressure depending on the load, depending on coal, in the range 2.5 ~ 3.8kPa. 2) find a wind speed is too low, the primary air temperature is lower than the normal value should be to lower the rotation speed corresponding to the normal to the powder of a primary air temperature and wind speed. 3) open, gas steam 2t boiler factory price industrial cambodia tank should be fully cut-off torch powder, the powder in the tube is blown accumulated powder. 4) Fire mouth clogged or coked should try to remove. What causes large vibrations induced draft fan? 1) motor bearings in oil, resulting in large vibration and bearing wear; 2) even when the shaft is mounted on the center not good; 3) induced draft fan stall surge; 4) anchor bolt loosening induced draft fan; 5) blade fouling or wear ,lost balance.

"Boiler" what should be changed: generally speaking, the 2t boiler factory price industrial cambodia is low utilization of heat energy, emissions of harmful substances more than traditional coal-fired boilers into high thermal efficiency, environmental protection index good clean natural gas boilers. Transformation into the device and then advanced through the premix, and the like of FGR combustion techniques wherein reducing combustion temperature of the fuel in the furnace, so as to achieve the purpose of reducing the emission of nitrogen oxides. Our project coal-fired boiler gas boiler can be changed. Coal was the main provider of energy and power in our country, but due to a variety of harmful substances produced by burning its disadvantages, gradually replaced by other energy sources. Natural gas because of its clean, environmentally friendly features widely loved by the people.

Temperature protection device during the fuel steam 2t boiler factory price industrial cambodia over temperature to regulate protective effect of temperature protection is an important procedure fuel steam boiler safe operation is particularly important for the regulation and protection of the boiler temperature of the fuel vapor; at the same time to regulate in the fuel steam boiler overtemperature Protective effects. Conventional boiler temperature protection means is a bimetallic temperature controller. Flame protection: prevent explosion of the furnace, steam boiler fuel flame protection means must be provided, is a function of combustion (including ignition, combustion or misfires when halfway off, typically within five seconds reignition monitoring the furnace, a second the run off into the oil (gas) solenoid valve, and turns on and audible alarm signal, when the blower continues to operate, the residual gas was purged of combustible furnace, after 20 to 30 seconds purge, automatically cut off and various auxiliary blowers supply the boiler operation stops. role is to monitor the flame signal the presence of a flame or an interrupt control apparatus mainly using a photomultiplier tube, a photovoltaic cell and photosensitive resistance, they have an infrared type or ultraviolet type a photoelectric conversion element, the working principle of the light converted to the corresponding strength of the radiation strength of current and the linear output state, sometimes weak induction current, through amplification, in order to have an effect on the controller.