10t Agent Price boiler Malaysia

After steam stop steam 10t agent price boiler malaysia, boiler water must be cleaned of dirt in the boiler must be cleaned and then dried with a slow fire, the installation of a diameter of about 10-30 mm in bulk in the boiler on the stove, on the boiler course it can not contact metal boiler volume kg 8 kg per square calculation. Finally, all wells, pipelines and other valves are closed.

Natural gas industrial 10t agent price boiler malaysias produce condensate water hazards natural gas industrial boilers produce condensate water hazards natural gas industrial boilers produce condensate water hazards 1, the corrosion of condensate water boiler heating surface major harm to the natural gas industrial boilers is the corrosive effect on the heating surface of the boiler. Condensate corrosion WNS rear of the boiler heating surface of the bottom of the tube focus, mainly iron oxide corrosion products. Condensate corrosion can cause intense side wall thinning, strength weakened. (1) condensation with the flue gas evolution corrosion, some CO2 is dissolved in the condensed water, CO2 generated in case of weak electrolyte H2O H2CO3, ionized hydrogen ions, so that a weak acid condensate, and another part of the nitrogen oxides and containing a very small amount of sulfur dioxide dissolved in the condensate, enhances the acidity of the condensate, the pH of the condensed water as in table 1 were lower than the position of the drum 4.3. iron hydrogen evolution corrosion can occur in the acidic solution, and the strong acid, the reaction The faster rate. (2) Since the oxygen etching gas during combustion boiler need to ensure a certain air ratio, combustion flue gas contains oxygen. When the steam condenses, some oxygen will be dissolved in the condensed water, causing corrosion of the metal heating surface of the oxygen. 2, when the cross-sectional area to reduce the flue gas flow type gas boiler industrial boilers operate at low load, the heated surface of the flue gas, the condensed water gathered in the smoke tube, the resulting corrosion products accumulate in the bottom of the tube, even clogging of the pipe part, thus reducing the flow area of ​​the flue gas, the flue gas resistance increases, and increase in power consumption of the blower. 3, the furnace temperature is lowered, damage to the burner within the examination of natural gas in industrial boilers, often find a certain amount of condensed water. We found condensate discharge tube boiler such severe congestion, resulting in condensed water in the lower furnace does not discharge, and refluxed for aggregation. When the boiler is started, the heat accumulated in the furnace absorbs the condensed water and evaporated fuel combustion, thereby reducing the furnace temperature. If the furnace condensate accumulated too much, and even dipped into the burner, causing damage to the burner. Suddenly turn off the boiler, the boiler does not start, because the burner too much condensation water immersion, affecting the safe operation of the boiler. 4. Effect of boiler condensate generated on the heat sealing material penetrates into the sealing material of the boiler insulation, the point of the arrow indicated gas tank gas boiler WNS industrial boilers. Sealing condensed water immersion insulation material for a long time, the insulation effect will be weakened or even physical damage, increased heat loss. Meanwhile, the condensed water will make the sealing material deformation aging, sealing capability weakened, leading to a certain amount of flue gas emissions, which not only be dangerous, can also cause a certain amount of heat loss.

Further: LDR, WDR type electric heating 10t agent price boiler malaysias represent the vertical and horizontal, R represents water, but is not expressed as a hot water boiler, LDR, WDR also electric heating type steam boiler.

It is understood that around prevention and control of air pollution, ecological Environmental Protection Office of Shaanxi Province has formulated the "Boiler Air Pollutants Emission Standards" ( "Standards"), amended the "off key industries in the region of atmospheric pollutant emission limits." In the future, biomass, alcohol fuel 10t agent price boiler malaysia emissions also be included in "Standards".

"Standard" is to integrate and improve the local air emissions standards boilers. "Standard" for the scope of the province, covering coal, gas, oil, various types of fuel such as biomass; using alcohol fuel (e.g., methanol, ethanol, dimethyl ether, etc.), gas-fired boiler with reference to the implementation of emission limits.

After calculation, coal-fired thermal power boilers in Shaanxi Province implementation of the new standards, particulate matter, sulfur dioxide, nitrogen oxide emissions respectively about 0.67 tons 15,200 tons, 1.26 tons, down 27%, 40%, 21%; Burning after transformation of coal boiler, particulate matter, sulfur dioxide, nitrogen oxide emissions can be about 01,400 tons, 1.42 tons 14,100 tons.

With the haze pollution reduction work to promote strong, Shaanxi Province coal-fired generating units and 20 steam tons / hour or more coal-fired boiler to carry out the transformation of ultra-low emissions, will gradually iron and steel, cement and other industries to carry over non-electric low-emission transformation, the original standard has been overtaken by change of environmental situation. Additionally, the Guanzhong area of ​​glass, ceramics, bricks, gold and other industry, there are a certain number of kiln, its environmental requirements leniency.

The revision of the "off key industries in the region air pollutant emission standards", the abolition of the thermal power industry, coal-fired boiler emission limit requirements, these two sectors rose to individual standards province-wide.

It also increases the coke nitrogen oxide emission limits Chemical Industries, gold industry, glass and glass products, ceramic industry emission limits, increasing the concentration of tile industries and atmospheric pollutants conversion approach.

The new standards are expected coke chemical industry NOx emissions will decrease 70%, the sintering process the steel industry, the particulate matter, SO2, NOx emissions decreased by 50%, 72% and 67%, respectively.