oil gas fuel water tube boiler use for textile mills

Gas oil fuel water tube boiler use for textile mills Burner Failures and gas boiler burners Failures and - best  a gas boiler, gas boiler burner ignition misfire rod reasons: 1, the ignition bar gap interposed carbon residue with oil. 2, ignition rods fragmentation. moist. Leakage. 3, the distance between the ignition does not stick, too long or short. 4, ignition rods Insulation damage, short to ground. 5, ignition cable and transformer failure: cable, connector damage caused by a short circuit during ignition; transformer break or other fault occurs. Measures following five: Clear, renewal, adjust the distance, change and switching transformer. Second, gas boiler, but spark ignition rods misfire reasons: 1, the cyclone disc space ventilation is blocked carbon, poor ventilation. 2, dirty oil nozzle clogging or wear. 3, the throttle angle is set too small. 4, the firing bar from the leading edge from the oil nozzle tip inappropriate (too protruding or retracted) 5, the first solenoid valve is an oil debris blocking gun (gun small kerosene). 6, oily or too viscous to flow easily clogged or the oil filtration system the valve is not opened, so that insufficient suction pump, oil pressure. 7, the filter pump itself blocked. 8, the oil more water (boiling abnormal noise within the heater). Measures are: Clear; first wash, such as not renewed; turndown test; adjusting the distance (in 3 ~ 4mm as well); Remove cleaning (cleaning the parts diesel); Check tubing and oil filters, insulation equipment ; remove peripheral screw pump, carefully remove the cover inside out oil network, with immersion oil; renewal of the test oil. Third, when the gas boiler and turn the fire a small fire normal, off, or flashing instability reasons: 1, the air volume damper setting fire too. 2, oil fires micro switch valve (damper outermost that group) inappropriate setting (set throttle air flow rate is greater than the fire). 3, oleaginous easy to spray viscosity is too high (heavy). 4, and the nozzle plate spacing cyclone inappropriate. 5, fire nozzle worn or dirty. 6, the preliminary fuel tank temperature is too high, so that the steam not smooth oil pump oil feed. 7, fuel oil boiler water. Action: Test gradually reduced; heating temperature; adjusting the distance (between 0 ~ 10mm); clean or replace; approximately set to about 50 deg.] C; or drain oil change. Fourth, the noise increases gas boiler burner reasons: 1, cut-off valve is closed or the passage into the fuel shortage, an oil filter blockage. 2, the oil inlet temperature is low, the oil viscosity is too high or the temperature is too high the pump inlet. 3, oil pump failure. 4, fan motor bearing damage. 5, dirty fan impeller. Processing methods: ① the oil line check valve is open, if the oil filter is working properly, the filter cleaning pump itself. ② heating oil or reduce the oil temperature. ③ Replace the oil pump. ④ replace motor or bearings. ⑤ cleaning fan wheel.

Free supervisory inspection principles and characteristics of small steam oil fuel water tube boiler use for textile mills as the country increasingly stringent security checks on special equipment, many users are in for acceptance steam boiler to worry about, then there a boiler inspection and acceptance does not require it? The answer is yes, this is the free acceptance boiler steam boiler, supervisory inspector now free to receive more and more small steam boiler users of all ages, so check the small steam boiler-free monitoring What are the principles and characteristics of it? Then we explain for everyone. First small steam boiler uses a very broad, such as industry, food processing, school canteens, washing rooms, hospital disinfection, hotels, district heating, etc., there are coal, oil and gas heating, where coal-fired steam boilers currently in my company alone this one domestic production, steam boilers do not build a separate boiler room, small size, light weight, easy to move, can be placed in the basement, roof, etc., the Boilermakers do not need to operate licensed fireman, replacing every year dealing with government departments, small steam boiler-free acceptance than conventional boiler safety, this boiler will not explode, it is composed of a coil, burning very fast start, whether it is coal, oil or gas to ensure 3 minutes to a steam, does not require inspection and monitoring of the subject. Overpressure, over-temperature combustion, water and other multiple protection, ultra-safe, non-explosive, can greatly reduce the burden on the user.

Gas-fired steam oil fuel water tube boiler use for textile mills which in modern industrial production, although the boiler very prominent role played by the choice of cleaning agent, but it is also very easy to scale boiler is subject to corrosion or damage. Gas boiler steam heater in such a situation therefore requires timely associated boiler equipment for cleaning, and performance of the practical utility of the most prominent non-gas-steam cleaners which is none other than this. Where a new gas heating system to replace the steam pipe cleaning agent must be used to eliminate the inner wall of debris so as not to affect gas-steam heat transfer efficiency and service life. It should be carefully checked, in use, to prevent water, acid, alkali and leakage into the low boilers using the system, and to install the filtration device, to prevent mechanical debris into the system to ensure the purity of the oil. A gas-steam with hot brands and process requirements, the correct selection of various grades of high-temperature gas-steam, and strictly abide by the provisions of the "organic heat carrier furnace Safety Technology Supervision" in the proper use of gas steam. Gas steam boiler at a high temperature gas for gas steam, gas, fuel furnace as a carrier, electric heating reactor and other heating devices, shall have the expansion tank and the oil sump and other security components and temperature control instruments and other facilities, to ensure safe operation. Purpose cleaners gas steam boiler is effectively rapid clearance gas steam boiler and the heat exchanger internal conduit accumulated soot and grease. Then we also have requirements on the cleaning agent, must not harm our metal heat transfer surface, requiring no residue, is completely dissolved, it must be easy to operate and requires only the use of the process in accordance with the needs of ordinary people to operate. Requires us on the gas boiler steam oven cleaners are: low energy environment, Wudu tasteless, non-flammable, irritation, can be directly discharged after cleaning.

"Henan 2018 campaign of air pollution control plan" recently introduced, to guide and encourage medium-sized coal-fired oil fuel water tube boiler use for textile millss eliminated. In the province's foundation 10 steam tons / hour and the coal-fired boiler Chaigai, and gradually expand the boiler removal and clean energy transformation of coal-fired range, before the end of 2020, the basic elimination of provincial cities planning area 35 steam tons / hour and coal-fired boilers.

Financial awards complement the way:

1, the completion of the coal-fired boiler Chaigai before the end of October 2018, giving not less than 60,000 yuan / tons of steam financial awards complement;

2, the completion of the coal-fired boiler Chaigai before the end of October 2019, giving not less than 40,000 yuan / tons of steam financial awards complement;

3, the completion of the coal-fired boiler Chaigai before the end of October 2020 no longer give financial awards complement.

Further, out of the boiler removal methods include eliminated, an alternative centralized heating boiler, coal gas, coal to electricity, use geothermal, wind, solar, biomass with baghouse, clean coal to burn not including , CWS, anthracite, semi-coke, green coke, crude oil, coal-fired boiler removal must be removed chimney or flue physical cutting, it does not have the complex production conditions. Do not use has been shut down, eliminated waste coal-fired boilers to cash rewards and subsidies. In the process of new coal-fired boilers to switch to natural gas to be synchronized to achieve low nitrogen transformation.