Calculated gas steam boiler greenhouse plant to explain your boiler heating area: Gas-fired steam boiler plant to you to explain the calculation method of gas steam boiler heating area of ​​the boiler, which is sure to install emissions-line monitoring devices, and, should environmental protection department of the monitoring center networking, so the job. And this kind of boiler heating area, specifically, then, is to be determined according to the location of the boiler, its usage and requirements. Generally speaking, if it is 1 ton, then, it is about 7000 square meters of heating area. 4 tons of gas steam boiler, which uses induced draft fan, then, that in the selection and configuration, generally speaking, if a different motor, then, there is a different choice, but specifically, then, is there are two First, Y5-47-6C, power is 15KW / 18.5kw, grade 2 is a motor; Second Y6-41-7.1C, power is 15kw / 18.5kw, the motor is four. 10 tons of gas steam boiler, between it and the workshop is to have a safe distance, and can not be a piece design, it must be independent. Therefore, it is generally to be more than 5 meters, so the job, however, can also be separated coal field.

The purchase of gas-fired boiler greenhouse, we are more anxious shopping center, but for gas-fired boilers are not very understanding. After the introduction of others, we understand each other fast boiler more comprehensive, and more trust fast boiler. After the boiler put into use, it turns out, party fast products fully meet the needs of our shopping centers. --customer feedback

If natural gas as boiler greenhouse fuel choice, because the convenience of clean natural gas and fuel used in the boiler service life will be over 10 years; but if it is a boiler coal or other fuels, it will shorten the life of some. Further, the life of the boiler with the use of the frequency, the higher the frequency the shorter the life of the boiler, the greater the contrary. Late boiler maintenance is also very important for the life of the boiler, good maintenance will extend the life of the boiler.

Gas oil furnace and expansion tank should pay attention to what effect the high slot: the gas oil furnace, I believe we will not feel strange, but should also have a certain degree of knowledge and understanding, if the box has been concerned about the boiler greenhouse site, and at the same time to carefully read the relevant article, and at the same time, to grasp their knowledge of words. So, based on this, then, we will continue this work, to promote a good learning process of the product, and so that everyone from a new harvest and inspiration. 1. Gas conducting oil conducting oil furnace exhaust port, which is typically what position the boiler on? HTF HTF furnace gas exhaust port, generally speaking, at the top of the boiler, i.e. high boiler shell. Furthermore, in this site, as well as the seat member, it is mainly used to install safety valve. Moreover, this drawing on the boiler, also will be marked out, as long as you can read drawings, you can, so can avoid making mistakes. 2. Gas expansion slot conducting oil furnace, which is in use, should pay attention to what issues? Gas expansion tank of oil furnace, the origin of their name, in part because of the boiler will heat transfer oil into the expansion slot, the expansion play a role. And this means that during erection, caution needs to be done is, it can not be damaged or broken. In addition, the oil level in the expansion tank, should be well controlled, so as to ensure the normal operation of the boiler.