gas fired boiler cost in bally

After the fired boiler cost in bally high cost of it? That renovation work is currently boiler have been carried out in various provinces and cities, many users are willing to transform doubt there will be a point, that is the high cost after the boiler yet? Then we took the coal-fired gas boiler renovation project for analysis. During the transformation of the former coal-fired boilers, there will be some need for coal storage, transportation costs, low operating efficiency of the boiler, the boiler thermal efficiency loss, loss of fuel costs caused by production costs caused by the loss of non-compliance; Then there will be coal-fired processing costs pollutant emissions boiler; and a lot of maintenance costs and labor costs continue to treat boiler site troubleshooting, and accounting of these costs are relatively high. After that say transformation, gas boilers belong first and foremost clean energy, to some extent, less waste emissions, it will save some gas treatment costs; In addition, the auxiliary gas boiler system more orderly is not complicated, so the run is relatively stable , operating efficiency is relatively high, so will enhance the operational boiler thermal efficiency to a certain extent, there is some improvement on return loss and the cost of fuel; at the same time, gas boiler this would not take up space, just to ensure perimeter clean can be, relatively speaking, save some labor costs, probably in terms of fuel, natural gas will be slightly more expensive than some of the coal, but the longer term, energy-saving effect of natural gas boilers, will be a period of time, return this part of the difference in money, but if management properly, will reach back to the results. After so the cost after the boiler strictly speaking, is not elevated, a certain time, will achieve cost reduction.

Fuel gas fired boiler cost in bally high degree of automation, higher operating costs than coal, small footprint, requiring less operator; while the gas boiler environmental factor is very high, is the fuel of the future of major equipment recommended.

You must know the fired boiler cost in bally energy problems (induced draft fan power consumption rate, steam consumption) draft fan causes problems 1.1 boiler flue dust and fouling, in particular air preheater fouling, resulting in increased resistance to smoke duct . 1.2 boiler flue, tail heating surface and dust leakage. 1.3 Leakage Rate large air preheater. 1.4 furnace excess air coefficient is too large. 1.5 unit load changes, run the adjustment is not timely, resulting in furnace pressure is too large. 1.6 unit load or low frequent starts and stops. 1.7 coal into the furnace worse, from the design value. 1.8 low efficiency filter. 1.9 draft fan blade badly worn, low operating efficiency. 1.10 fan outlet flue gas desulfurization big resistance. 1.11 soda boiler pipes for leaks. 2, 2.1 to 2.1.1 operational measures to solve the problem of the strict implementation of soot blowing system to prevent the heated area ash, blocking ash, flue gas system to reduce resistance. 2.1.2 holding the induced draft fan, the flue gas separator baffles and dampers in the fully open position. 2.1.3 The experiment showed combustion boiler, proper control of excess air in the furnace. 2.1.4 adjustment chamber negative pressure, air leakage reduction furnace and the flue. 2.2 routine maintenance and testing 2.2.1 induced draft fan performance test to determine the optimum operating point and efficient workspace. 2.2.2 boiler, air preheater, a flue, ESP and other system leakage inspection, process. 2.2.3 timely check processing chassis, shaft seal leakage. 2.3C / D repair, eliminating defects 2.3.1 down strict accordance with movement clearance adjusting fan. 2.3.2 induced draft fan blade defect action elimination hand vane opening adjustment. 2.3.3 Importers and induced draft fan baffle opening check. 2.3.4 duct tightness check process. 2.3.5 wave plate replacement air preheater, rinsed sector plate gap adjustment. 2.3.6 eliminate dust defects and improve collection efficiency. 2.3.7 clean flue gas desulfurization system, flue resistance is reduced. 2.3.8 eliminate soda boiler pipe leakage defects. 2.4A / B repair and transformation 2.4.1 Check and repair the fan blades, replace seriously damaged blades if necessary. 2.4.2 for energy saving fan efficiency below 75%. 2.4.3 The fan motor frequency transformation. 2.4.4 of the precipitator, if necessary, transform and improve collection efficiency.

Food is food industry is human life industry, but also an ancient and eternal evergreen industry. Industrial steam fired boiler cost in bally as an integral part of the chain, is mainly used for processing of distillation, extraction, sterilizing, drying, curing and other processes. Anqing City, Anhui Province is located in the Want Want Foods Co., Ltd. mainly engaged in all kinds of puffed food processing and manufacturing and sale of steam boiler steam delivered directly or indirectly in contact with food, thus requiring the steam quality is very high. Due to expanding production needs, Want Want Foods in urgent need of a boiler plant to provide high-quality steam. After a comprehensive understanding of the boiler industry, determined to cooperate with the fast boiler. Want fast square perennial cooperation with the country's food company, it has considerable experience of cooperation. By understanding the needs of the Want Want food production, providing a whole 10 tons of steam condensing gas steam boiler (WNS10-1.25-Y.Q).