Distributor hot water boiler 20 ton Commercial Laos

To proceed from reality, should be in accordance with the electric power, gas should the gas, the coal should be coal, should be hot the thermal principle, promote the use of all kinds of clean energy for winter heating cleaning. In order to reduce air pollution and protect people's warm winter as a foothold to enterprises, government promotion, residents can withstand the principle of gas after the first change to gas will change in gas assurance, the price is acceptable on the basis of sound promote the "coal to gas" and central heating engineering, in district heating supply pipe network can not cover, vigorously implement the replacement of coal-fired power heating project.

Good job of marketing system storage capacity for natural gas. Accelerate the construction of natural gas transmission and distribution network, the new natural gas volume priority for life and severe winter areas of urban air pollution and coal for heating alternative. In principle, to new natural gas cogeneration and gas chemical projects.

Accelerate agricultural and pastoral areas "coal to electricity," the process of upgrading the power grid. Coordinate development of power transmission project construction, etc. are encouraged to promote the regenerative electric heating. Around on the "coal to electricity" project supporting grid should be given support, coordination "of coal to electricity," "coal to gas" land for construction.

In accordance with national requirements, shutting down environmental protection, energy consumption, safety and other 300,000 kilowatts coal-fired units of non-compliance. For shutting down the unit's capacity, coal consumption and emissions targets, allowed to trade or replacement, can co-ordinate arrangements for building the capacity of ultra-low emission coal-fired units.

According to air quality improvement requirements to accelerate the delineation of high-pollution fuel combustion zone ban and to expand the scope of, and actively promote the elimination of small coal-fired boilers. The county level and above urban area basically eliminated 10 tons of steam per hour and coal-fired boilers and tea furnace, stove and other operating coal-fired facilities, in principle, to 35 tons of steam per hour, the new coal-fired boilers, in principle, other areas on no new 10 tons of steam per hour of coal-fired boilers. While banned out of coal-fired boilers, pressure boilers market regulators cancellation of registration certificate to use.

Chemical plant flue gas boiler house design parameters required chemical plant flue gas boiler house design parameters required for the design of the boiler room when the chemical plant for flue design is also a requirement, if the design does not meet the specifications, then the words of the late , but also will cause great trouble. So, for chemical plants, it must be easy to overlook these places also to pay attention to it. Otherwise, if the latter then rework it, the loss will be greater. 1. The flue should be straight, air tightness, attachment and less and less resistance, horizontal flue persist for more than 1% of the laying head should be positioned to avoid Longitudinal placement. 2. Fuel gas-fired boiler house and chimney flue should be used to build a steel or reinforced concrete, the lowest point of the flue and chimney should be set lump water-sealed water drains. 3. The thickness of the metal plate is generally used in flue 4 ~ 6mm, flue planning, equipment should meet the reinforcing ribs to ensure the strength and stiffness requirements. 4. The thermal expansion of the flue should be compensated, and the compensation amount should be accounted for proper selection. The insulation should be of steel flue ways and reliable fixation. 6. The fuel gas boiler corresponds to a boiler should be a chimney, when subject to the conditions required several constraints when sharing a boiler flue or chimney, each boiler should be ventilated suction force balance. 7. The flue should be arranged to set the necessary thermal and environmental measurement points measurement points in the right orientation. Additional single evaporation equal to 20t / h or a single additional fuel boiler thermal power of 14MW or greater, it is necessary to monitor successive fixed soot, SO2 concentration in flue gas discharge apparatus. 8. In the simple collection of local and smoke when many boilers a share or a total chimney flue shall be fitted with explosion-proof door on the flue after each fuel gas-fired boiler, the orientation of the vent should be conducive to relief, shall be located in the proper orientation before and do not endanger the safety of the turn, when the gas blast may endanger the safety of the operator is full, the guide tube should be installed on the pressure relief explosion-proof equipment. 9. For some longer flue boiler room, they should be accounted for resistance, select the appropriate blower, Fan (when there is draft fan), in order to ensure clear smoke. 10. The chimney should be considered appropriate preservation approach, the chimneys of flue gas temperature should be above the dew point of the flue gas temperature of 15 deg.] C; when the exhaust gas temperature is lower than the dew point temperature of flue gas, the flue gas should take effective measures to avoid the intrusion.

Now the steam boiler safety guarantee? For now, when the boiler equipment to be understood, you will find such a device could make it in a lot of places will use to a heating device, such as schools, in factories, but will pass boiler equipment to hot water needed, and that at the same time, it also began with the emergence of a steam boiler plant, it can help to a large number of industries, to complete the heating and so on. And as long as this is the time for steam boiler plant to find out about, you will find such devices, mainly to be able to carry out heating, but also can provide steam production required, so become a lot of industry in the equipment will be used to, for the time that the use of such devices, which safety equipment problems, became worthwhile to pay attention to the problem. As long as the time to understand for such a device, you will find such a device can be said to have safety devices to ensure the safety of them, and one of the power protection devices, timeliness is not then guard people, too can go to make this more of a safety device, it is possible to make too many companies making use of that time, is completely without worrying about security issues, so that such devices can get a good application. Today, the steam boiler plant, it should be said to be a lot of places will use the equipment, and that with the improvement of boiler equipment now in production processes, as well as in terms of safety, so that such devices are starting to become there are more security, you can become among the many industry can use directly to the device.

Third, the auxiliary mobile device is ready to put in place

Condensing gas boiler body is much larger tonnage are relatively large and difficult to move, move, or just rely on manual handling basic unrealistic. Only by means of some large hook hanging class machinery and equipment to be placed in the appropriate boiler installation location, so before installing the boiler, we need to move these auxiliary equipment ready.