As one of Beijing's air pollution emission standards of the most demanding urban, environmental control is very strict. Beijing primary school campus Emerald City as one of the cradles of socialist culture successor, in terms of the quality of students' learning environment is put emphasis on one hundred percent. October 2017, Beijing primary school campus Emerald City with my company, signed a two Thalia T6 series vacuum building heating fired hot water boiler for winter heating use.

The two series of oil and gas boilers produced by ZBG are condensed low-nitrogen environmentally friendly boilers. Low nitrogen technology is used to achieve low nitrogen emissions from boilers. The boiler is equipped with a condenser and an economizer to absorb the sensible heat in the high-temperature flue gas discharged from the boiler and the latent heat released by the condensation of water vapor to improve the thermal efficiency of the boiler. These two boilers are also fast-assembling boilers, which are compact in structure, easy to transport, easy to install and short in cycle.

SZS series gas-fired superheated steam boiler project for heating industryXinzheng Heli Thermal Co., Ltd. is a company specializing in heat energy production and central heating supplying, providing heat source for winter heating for people in Xinzheng . Facing the increasingly serious environmental problems, Xinzheng Heli decided to respond positively to the "coal to gas" policy, using clean energy natural gas as boiler fuel and introducing high efficient gas-fired boilers to replace the original coal-fired boilers. For this, Xinzheng Heli Thermal carried out an open bidding. After competitive bidding and strict selection,ZOZEN defeated other competitors and won the bid with its comprehensive corporate strength. The winning bid was ZOZEN energy saving and environmental protection product - SZS series condensing gas-fired superheated steam boiler (3 sets of SZS75-1.6-Q). The furnace and the front and rear walls of this series of boilers adopt membrane water wall structure, and the airtightness is good. The large furnace design is combined with an advanced ultra-low NOx burner to ensure sufficient fuel combustion, controlling the NOx emissions below 30mg/m³ and the thermal efficiency up to 98%. At the same time, the boilers adopted the flue gas recirculation technology and were equipped with economizers and condensers at the tail of the boiler flue, which not only followed the concept of energy conservation and environmental protection, but also met the thermal energy requirements required by the project.

Check before 1 building heating fired hot water boiler operation, including the use of internal inspection and boiler ready. 2, stove and flue inspection, stove and chimney soot and debris should be removed. Gas hot water boiler with environmental protection, energy conservation, safety, salient features fully automatic operation, and ease of use. In addition, due to the operation of the economy, government policies to encourage, gas hot water boiler more and more people of all ages. To adjust the door and the flue duct, the door must be complete and tight, the switch must be flexible, open and close indication must be accurate. 3, boiler accessories conduct inspections of safety accessories in good condition; if the plug rotating flexible, convenient; all kinds of instruments and controls should be complete, good, clean. After examination by the pressure gauge cocks should be in working condition. 4, check Zidongkongzhi system. Biomass boiler categories: biomass boilers Horizontal, vertical biomass boilers. Biomass gas thermal oil heaters, biomass steam boiler, biomass hot water boiler, biomass oil furnace. 5, check the auxiliary equipment. Steam boiler is an energy conversion device, the energy input to the boiler fuel chemical energy, electrical energy, thermal energy and other forms of high temperature flue gas, and after converting the boiler, the steam output having a certain outside thermal energy, high-temperature hot water or an organic carrier. 6, the combustion device checks to see if the combustion device is in good condition; for mechanical transmission, coal handling system, ballast system, steering normal test; safety spring gearbox lubrication should be properly compacted and; Crosscut indicate the correct scale. Iron Eagle neatly intact, complete ballast plate, flexible movement. 7, the auxiliary heating surface inspection, check the auxiliary device (fan, water pump, etc.) is firmly connected to the coupling; v-belts suitably loose; good enough lubricating oil; cooling water flow. After the check, the safety shield is mounted, a separate test run, the idle current note.