Fully Automatic 2t oil boiler Industrial Brunei

To the end of October 2020 to complete Chaigai coal-fired fully automatic 2t boiler industrial bruneis no longer give financial awards complement.

Further, out of the boiler removal methods include eliminated, an alternative centralized heating boiler, coal gas, coal to electricity, use geothermal, wind, solar, biomass with baghouse, clean coal to burn not including , CWS, anthracite, semi-coke, green coke, crude oil, coal-fired boiler removal must be removed chimney or flue physical cutting, it does not have the complex production conditions. Do not use has been shut down, eliminated waste coal-fired boilers to cash rewards and subsidies. In the process of new coal-fired boilers to switch to natural gas to be synchronized to achieve low nitrogen transformation.

Using Ultraten wings condensation fully automatic 2t boiler industrial brunei technology has greatly enhanced heat the heating rate; silicon alloy material design to achieve the depth of the condensing heat exchanger, high efficiency, high heat transfer speed. "APH the T7" ready to use the factory mode, the system design is simple and clear, i.e. security that is used, the best burner performance debugging the factory, the user can simply set up at the installation site, connected to gas, water, to a flue , it covers an area of ​​greatly reduced.

Boiler and steam fully automatic 2t boiler industrial brunei comparison on the specific types of boilers, the following will be involved for the boiler this specific type of boiler. Moreover, because it is widely used, as well as website products and keywords, it is necessary to have an in-depth and comprehensive understanding so that it does not miss any of its knowledge points, and at the same time, it can also make the product have a good use effect, So that we can benefit from it. 1. Are boilers and steam boilers comparable? Boilers and steam boilers, these are two specific types of boilers, but from a professional point of view, these are two completely different kinds of boilers, although they are both large in the boiler. Class. Therefore, the boiler and steam boiler are not comparable, and are not suitable for comparison, because the comparison is of little significance and value. 2. What should be the choice of the high temperature used in the boiler? The high temperature used by the boiler shall be selected according to the grades and requirements of the heat use process, and the high temperatures of all grades shall be correctly selected, and the requirements of the Standard of Safety Technical Supervision for Organic Heat Carrier Furnaces shall be strictly complied with. So that they can be used correctly. 3. Is there a difference between the heater and the boiler? Heaters and boilers, though similar in name, are two different things. Because, Heaters are heated with resistance, while boilers use fuel, such as coal and natural gas, to provide heat. In addition, they are also very different in the use of oil.

The customer asked: what should I do after the fuel-fired fully automatic 2t boiler industrial brunei is put out?

Fangkuai Boiler Company replied: in case of quenching, the fuel supply of the furnace must be cut off immediately, the electromagnetic valve for gas supply (oil supply and return oil) will be closed, and then the fuel supply valve for each burner shall be closed. Operate quickly so as not to cause a vicious risk when fuel continues or resumes supply. At the same time, find out the causes of boiler quenching, remove the found faults, and make preparations for restarting.