2 ton gas fired boiler 1 ton gas fired boiler

In the 2 ton fired boiler 1 ton fired boiler market, oil and gas boilers, coal-fired boilers, and biomass boilers occupy almost the entire market. Among them, many countries and regions have demanded the use of clean boilers because of their emphasis on environmental protection, which has also promoted the development of environmentally friendly oil and gas boiler manufacturers.

Dairy production and processing sectors, need a lot of steam on food drying, sterilization, stereotypes, such as processing, steam 2 ton fired boiler 1 ton fired boiler essential. Xinjiang Ake Su Xinnong Dairy Co., Ltd. as a local brand, has a large market users. 2016, Akzo increased demand for dairy production, the original steam boiler company can not meet today's production needs. In the same year, Akzo dairy cooperation with our company, signed a series SZS 6 tons of steam pipe steam boilers, steam support for the dairy industry dairy production Aksu.

The 4ton biomass steam 2 ton fired boiler 1 ton fired boiler is specifically designed to use biomass pellets as fuel. Installed at Vietnam, a tobacco processing facility, the boiler reduces the use of fossil gas. Operating at 16 bar pressure, the boiler has a nominal capacity of 4 ton per hour of dry, saturated steam.

How to set the height of the 2 ton fired boiler 1 ton fired boiler chimney

The coal fired boiler can be divided into two kinds:vertical boiler and horizontal boiler. And the horizontal boiler is very economic because of its long flue gas flow, slow smoke discharge, high heating efficiency. So it is widely sued in the market. After buying a boiler, it is necessary for them to build a boiler room,in the installation the height of the chimney also need to pay attention. According to the ZG engineer, the chimney height should be accordance with the lowest height of GB13271-2001 stipulation. Only one chimney is allowed in a boiler room. The specific requirements was listed below:

1.When the boiler’s output capacity is more than 1t/h or 0.7MW, a permanent thief hatch and relevant facilities should be setted in compliance with the stipulations of measuring method for smoke and dust of boiler emission, and The determination of particulates and sampling methods of gaseous pollutants emitted from exhaust gas of stationary source.

2. The exit diameter of the chimney should be not lower than the largest load. The smoke flow should not be too fast. when the load of the coal fired boiler is at its lowest level, the velocity of the chimney exit should not lower than 2.5~3m/s.

3. If the chimney heat does not reach the height of the above stipulations, the maximum discharge concentration of the dust,sulfur dioxide, nitric dioxide should be carried out at 50% of the corresponding area and time emissions standard .