blown gas waste heat boiler fuel

The picture shows the WNS series horizontal fire tube blown waste heat boiler fuel produced by ZG boiler. This boiler is an oil and gas boiler. It mainly uses natural gas, petroleum, light oil and heavy oil as fuel, and has the characteristics of high thermal efficiency and environmental protection.

How to put ordinary gas blown waste heat boiler fuel boiler emissions become low nitrogen boiler is an important cause of air pollution in order to reduce pollution of the boiler, in the country minus the cancellation of coal coal have done a lot of work, which significantly reduces the solid boiler soot emissions and sulfur dioxide emissions of polluting gases. But only coal-fired boilers will be replaced by gas-fired boilers, boiler did not reduce emissions of nitrogen oxides, so the boiler with a new task becomes low nitrogen boiler boiler also became current. In the end what is low nitrogen boiler? In many areas, there is no mandatory use of low nitrogen boiler regulations, and in Beijing, mandatory use of low nitrogen requirements of the boiler has been formally introduced in April 1 this year, the existing boiler will perform the following 80mg standard, the new boiler will perform the following criteria 30mg, 80mg and standard criteria will gradually be replaced by 30mg of the boiler, and therefore in Beijing, boiler NOx emissions less than 30mg in order to become a low-nitrogen boiler. In Henan, the new gas-fired boiler will also perform the following criteria 30mg of nitrogen oxides, we can safely predict that the future low nitrogen boiler will be large-scale promotion. At this stage, a lot of nitrogen oxide emissions from gas-fired boiler in 150mg or less, which is far unable to meet the standard low-nitrogen boiler. Ordinary means into a low nitrogen gas boiler with a boiler or low nitrogen transformation replace the original boiler is condensed into nitrogen oxides emissions below 30mg (formula) boiler. Nitrogen mainly low boiler transformation replace Burner, mainly in the following ways: 1, flue gas recirculation transformation (Ultra Low NOx) is the use of combustion air head, the part of the combustion fumes sucked back into burner, and combustion air mixture. Since the flue gas recirculation, the combustion fumes a large heat capacity, the combustion temperature is lowered, the NOx reduction. Another recirculation burner itself is directly recycled into the part of the fumes inside the burner and to the combustion process, the burner has such a suppression effect of nitric oxide and the double energy. 2, the premix burner (combustion surface) technology premix gas burner, the gas and air are thoroughly pre-mixed prior to entering the combustion chamber, so that more complete combustion, improve the combustion efficiency and reduce harmful emissions, but also can reduce the space requirements of the combustion chamber, is currently the most advanced of a gas combustion technology. Due to the low NOx combustion boiler renovation and diverse, sophisticated technology, in order to ensure the smooth implementation of the transformation, effectively preventing security risks, prevent accidents, analysis and appraisal by experts, comprehensive security, environmental factors, Beijing and the Beijing Municipal Environmental Quality and Technical Supervision protection Bureau jointly issued a notice :( a) for 7.0mw (evaporation 10t / h) or more in the boiler is not recommended transformation of the way premixed combustion. (B) to the central back-fired boilers, the transformation is not recommended way to replace the burner. (C) For boilers, does not recommend the use of direct transformation of the way the transformation of the burner. Therefore, a low nitrogen transformation process boiler, more often, is a direct replacement for the original gas boiler low nitrogen boiler.

A number of factors cause the pressure of the heat efficiency of the blown waste heat boiler fuel module are carrying substantially all parts of the coal gas impressive work, use a large extent, avoided the module boiler fouling contamination, while discharging hazardous gas like nitrogen oxides obtained a clamp. Thermal efficiency is an important measure of the rule module boiler, let us study the cause of a number of factors under the pressure of the thermal efficiency of the boiler module. After inquire about the personnel, boiler heat loss module is mainly produced in the bear on these two: the proportion of full combustion air with smoke emission unreasonable heat loss. Reduce smoke emission install heat loss can be recovered in the flue gas waste heat boiler module terminal fitting, or use more advanced features of FGR boiler. The combustion air fully proportional unreasonable non-compliant analysis: General ejector module boiler burner, causing the air-fuel ratio is no way to maneuver to mobilize. Part of the boiler module using a mechanical blower burner, resulting in unreasonable cause fuel ratio factors are the following: the main air-fuel ratio unreasonable encompass divided into two cases: when oxygen is excessive, the excess will be numerous cold is heated, resulting in increased cost of energy boiler module, the thermal efficiency of the boiler module lowered; when oxygen is non-compliance, will produce incomplete combustion occurs module boiler heat efficiency is lowered.

To conscientiously implement the CPC Central Committee and State Council "on the overall strengthening of environmental protection and resolutely fight pollution prevention advice tough fight" and "the State Council on the issuance of three-year winning the Battle of the blue sky plan of action," the spirit, blown waste heat boiler fuel emissions control, prevention and treatment air pollution, the State environmental Protection Department to develop "boiler air pollutant emission standards." In order to further the implementation of air pollution control operations, all regions at the same time meet the national standard, but also have introduced a more stringent local standards.

From the implementation of the Beijing gas nitrogen oxide emission standards for boilers began 30mg, emissions from gas-fired boiler has been of great concern, expand around the "coal to gas" action, so that gas such devices become the most countries to promote clean energy boiler.

The transformation of the current common low nitrogen boiler, there are three main measures: (1) replacement of boilers, (2) replace the burner (3) in the boiler flue gas treatment.

Controlling the nitrogen oxide generated from the source, the most advanced technology on the market today is the use of flue gas recirculation techniques and FGR premix combustion gas boiler technology, both having different focus, low nitrogen emissions boiler.

Replace the boiler burner, renovation and debugging, and the impact on the safety performance of the resulting boiler, burner unit by the responsible manufacturer or his authorized. Beijing Bureau of Quality and Technical Supervision, Beijing Municipal Environmental Protection Bureau issued the "Notice on the transformation of the low - NOx combustion safety risk warning" states: the transformation of low-nitrogen combustion boiler diverse, complex technology, to protect the smooth implementation of the work of reform, effective prevent security risks, prevent accidents, analysis and appraisal by experts, it is not recommended comprehensive safety, environmental factors, the following recommendations:

Nitrogen oxides have been generated by some means and then reduced to nitrogen, the main fuel reburning, selective catalytic reduction, selective non-catalytic reduction. But in the actual monitoring, the nitrogen oxide emissions controllability is poor.

The transformation of low nitrogen gas boiler is a need for long-term adherence and actively manage the work, under the premise to meet the national standards, do specifically address the specific circumstances, not blindly, careless handling, to adopt plans, goals, ideas implementation, to achieve a comprehensive upgrade gas boiler.