Distributor 10t Natural Gas boiler Commercial Thailand

Hebei Cangzhou issued a "special program on the implementation of standards of governance distributor 10t boiler commercial thailand." Emission standards for boiler treatment and corresponding indication made, as shown in details as follows.

First, the standard standard coal-fired boiler

1, before the end of September 2019, within the city of more than 35 tons of steam / hour ultra-low emission coal-fired boilers complete transformation, emissions of major pollutants to achieve ultra-low emission standards (dust ≤10mg / m³, SO2≤35mg / m³, NOx≤50mg / m³).

Before the end of the year 2/2020, the city eliminated 35 tons of steam / hour and coal-fired boiler, stove and stove operating a small coal stove, achieved within the city 35 steam tons / hour and the boiler "No Coal." Reserved 35 steam tons / hour and coal-fired boiler, stove and stove operating a small coal stove implementation of the special emission standards (dust ≤30mg / m3, SO2≤200mg / m3, NOx≤200mg / m3).

Retention of more than 35 tons of steam / h coal-fired boiler to install air pollution automatic monitoring facilities and networking with the environment department, to install a distributed control system (DCS system), real-time monitoring of pollutant emissions.

Second, gas-fired boiler

1, before the end of September 2019, the city completed two-thirds of the total number of units of low-nitrogen transformation gas boiler above. Among them, the central city of all gas-fired boiler and all the city's industrial and commercial gas-fired boilers to complete a full rebuilding mode low nitrogen.

2, the end of June 2020, the conventional gas boiler should be completed by transformation of a low nitrogen combustion, soot, sulfur dioxide and nitrogen oxide respectively 5mg / m³, 10mg / m³, 30mg / m³.

Third, the task

1, increase clean energy alternatives. In areas not covered by central heating pipe network, and vigorously promote geothermal, wind, solar and other clean energy, in an orderly way from coal to gas and coal to electricity, to change the power-based. In 2020, under the conditions of gas supply has been guaranteed, the city eliminated 35 tons of steam / hour and below the coal-fired boilers.

2, increase the coal management and control efforts. Coal infrared video monitoring devices to increase coal quality sampling efforts, to retain the blast furnace coal-fired boilers to be installed, Hebei coal to meet local standards "Industrial and domestic fuel coal" (DB13 / 208102014) non-coal power generation industry quality indicators .

3, strict new boiler access. Ⅲ class urban area and high-pollution fuel combustion zone ban municipal government designated a ban on new coal-fired boiler, a citywide ban on new 35 steam tons / hour and coal-fired boilers, the new 35 steam tons / hour of coal-fired boilers must in line with the municipal government of central heating planning or construction of industrial parks planning, energy efficiency reached AQSIQ "energy-saving technology supervision and management procedures boiler (TSGG0002-2010)" requirements, encourage the use of "energy efficient boiler promotion List" reached the level of energy efficiency standards boiler, pollutant emissions to meet emission standards require extremely low.

Many companies need to use distributor 10t boiler commercial thailands, and oil and gas boilers are a very common type of boiler. How to use oil and gas boilers?

Oil and gas distributor 10t boiler commercial thailands in overseas markets

Biomass boilers are very popular in overseas markets due to their energy saving and environmental protection characteristics, but oil and gas boilers are selling well in overseas markets due to their ease of use, high efficiency, and environmental protection.

Gas oil furnace gauge acceptance and prohibit the use of instructions for conducting oil furnace oil furnace gas this kind, since both sites distributor 10t boiler commercial thailand products, is one of the sites keywords, therefore, requires a comprehensive knowledge and understanding. Moreover, it is also a common oil furnace type. Therefore, only familiar with this kind of boiler, we have the right to use, so a lot of benefit to themselves. 1. Gas oil furnace acceptance for this kind of a gas oil furnace oil furnace, which work in the acceptance, the main, are: First, when a gas oil furnace transported to the installation site, the manufacturer should be based on factory inventory, an inventory of its parts, whether there are missing and so on. Then, according to the boiler drawings, review of equipment, mainly to check its associated integrity. For example, the large boiler, during transportation, whether there is damage or deformation such problems. 2. Gas oil furnace gas pipeline for oil furnace installation, in which the pipeline installation, requirements mainly refer to "Heat Transfer Fluid heaters Safety Supervision" in, and should refer to product specifications, as well as the process of FIG. to carry out. For the line connection port, in addition to the flange on the connection should be used to this kind of welding. In addition, the pipeline arrangement, there should be a slope, typically from 2% to 3%. In the high line, an exhaust port shall be provided, at its low due outfall. For straight line pipe, if the length is more than 20m, then there should be a thermal expansion joint. 3. conducting oil furnace gas gauge, when the circumstances under which can not be used? In the gas oil furnace, pressure gauge is an important instrument, but if some situation, then can not continue to use its specific terms, it is as follows: Case 1: broken glass on the pressure gauge, or its dial scale is unclear, unrecognizable. Case 2: Pressure gauge seal is damaged, or it exceeds the test period. Three cases: for a limited gauge nail stop, if there is no pressure, the pointer can not limiting, the staple at the back. If the nail is not limiting, pressure gauge, in the absence of pressure, which is the distance between the pointer and the zero position, more than a predetermined allowable error range.