Energy Saving Dealer 4t oil steam boiler Myanmar

Tail secondary combustion flue how to deal with the phenomenon of a sharp increase in rear of the boiler flue secondary combustion flue temperature location and later. 2, the furnace, the flue abrupt change in negative pressure, flue gas is not tight at the smoke, the Mars. 3, air preheater large current swing bearing housing temperature, severe Jam occurs. 4, air preheater fire alarm issue. 5, steam temperature, economizer outlet water temperature, the air temperature rises abnormally. 6, induced draft fan vanes automatically open a large, Fan current rise. 7, as the combustion side, both sides of the smoke temperature difference increases. Reason 1, through the coarse fine grinding coal, coal poor uniformity, improper adjustment of combustion, combustion of fuel is insufficient, serious mechanical incomplete combustion, and high levels of combustible ash accumulated in the back pass. 2, an oil burner or an oil poor atomization, so that unburned droplets deposited in the flue. 3, prolonged low load operation of boiler, the furnace temperature is too low or too small amount of excess air resulting in incomplete combustion of coal or oil accumulated in the tail. 4, after the shutdown of the fuel leakage into the furnace and accumulates or after shutdown and to insufficient MFT furnace purge unburnt coal or oil accumulation at the end of the tail. 5, soot blower failure, long-term put into operation is not normal. 1 process, when a slight secondary combustion, exhaust gas temperature does not rise within 20 ℃ normal smoking temperature should be checked immediately paragraphs, the combustion site and judge whether the secondary steam soot blowing. (When the exhaust gas temperature rises to 250 ℃) 2, the operation of the back pass and then generating boiler combustion boiler operation should be stopped immediately, immediately stop sending, ID fan and turn off all the smoke and steam soot blowing air damper fire. 3, if the economizer afterburning, until the storage tank level control valve blocking off without pressure, flow rate of feed pump motor start 150t / h Sheung be cooled. 4, air preheater heating surface of the secondary combustion air preheater normal operation, normal operation of the air pre-heater holder; air preheater Jam occurs, the main drive motor and the auxiliary drive motor trip, contact maintenance manual plate moving continuous air preheater rotor. Soot blowing steam into air preheater for extinguishing, into the air preheater for fire extinguishing can not be extinguished. 5, the economizer outlet water temperature close to the inlet temperature (at the economizer secondary combustion), the air preheater inlet gas temperature, exhaust gas temperature, the hot air temperature is lowered to less 80 ℃, each one hole, and the hole is no longer Mars smoke and soot blowing steam stops coming out after water or fire. Open hole inspection manhole and inspection to confirm the secondary combustion goes out, after the flue vent door open to drain water inside the smoke flue opening for ventilation air damper. 6, to be re-combustion is resolved, the flue temperature does not rise and fall when stabilized, before slow regulation of the air, smoke baffle, the necessary air cooling and purging.

The characteristics of the fuel gas energy saving dealer 4t steam boiler myanmar: 1, burner gas steam boiler is supplied by well-known manufacturers in the world, burn automatically stop controller in accordance with instructions, a separate control box has a number of security, safety and stable performance, low maintenance. 2, advanced automatic steam boiler controller, Chinese LCD screen, the man-machine interface, the user simply easily set, i.e., according to user requirements boiler start and stop, load adjustment, automatic water supply, such as automatic operation. Boiler fully functional, complete protection, easy to operate, safe, reliable, self-diagnostic function. Boiler operation anomalies automatically interrupt burning, audible alarm once appeared. 3, the steam boiler burner mode is set, double return configuration, fuel combustion, boiler stable; inserted spoiler smoke tube, smoke slow speed, increase heat transfer, a high thermal efficiency, and reduce cost. Gas fuel oil boiler 4, horizontal steam boiler shell type three return all wet back downstream pyrotechnic pipe structure, i.e. increase the strength of the heat absorption of the boiler, but also to meet the needs of thermal expansion of the heating surface, scientific and rational, prolonged durable. 5, in strict accordance with the present boiler "Steam Boiler Safety Supervision", JB / T10094-2002 "industrial boilers general technical conditions", JB / T1619-2002 "boiler manufacturing technology conditions potshell" requirements, design, manufacture, monitoring inspection to ensure good quality of boilers, achieve low energy consumption, high thermal efficiency, stable pressure, gas and quantity, economic use. 6, a large boiler furnace space, storage, steam and more adaptable load capacity. Rational design of steam separator apparatus built to meet user requirements need to use higher quality steam. Furnace open manhole, head holes, hand holes, to facilitate the internal furnace to clean up, make repairs, maintenance is very convenient. 7, is provided with a multi-stage boiler safety interlock protection: Pressure switch protection (higher than the set auto stop and pressure), low water protection (boiler water level is below the body of the warning level, the alarm and automatically cut off power), the protection valve (boiler pressure exceeds the pressure of work, discouraged automatic blood pressure) to ensure foolproof boiler in a variety of conditions, safe home. 8, the combined organic appearance of mechatronic, sophisticated new, compact, less space, easy to transport and install. 9, using the new material and the thermal insulation quality white color plate package, lighter in weight, good insulation properties, beautiful, not rust.

When the weather gets colder and colder, people will choose different ways of heating, one of which is more convenient is the fuel-fired boiler, but many people do not understand his use, so take a look at the following. Classification: fuel-fired boiler is a kind of boiler which uses diesel oil, waste oil and so on. Its overall structure and arrangement are similar to coal-fired boilers, and the common classification is mechanical and steam materialized. Features: the bottom of the oil-fired boiler is mostly made of the heat preservation bottom tilted to the back wall, which is the bottom of the heat preservation furnace, in order to obtain good combustion characteristics. This kind of boiler, for those who do not have a natural gas pipeline, also hope The oil-fired boiler is a good choice when the cost of normal operation of the boiler is low. The fuel-fired boiler is an important symbol of the progress of the times, in order to serve the human being well and further perfect according to the needs of the people.

We have long known that fast boiler this brand, high-tech enterprises in Henan Province, the most influential brand, technology entrepreneurs contribution to enterprise and many other honors, so that our brand is very interested in each other fast. Through this collaboration, proving once again that our decision is not wrong, 15 tons of steam condensing gas boiler provides steam to fully meet the needs of our dairy products processing plant. --customer feedback