100ton liquefied petroleum gas boiler in the philippines

In accordance with article 1.2 13.3.6 to 13.3.8 "100ton liquefied petroleum boiler in the philippines design specifications" (GB50041-92): gas-fired boiler provided in the other buildings should be not less than 3 times the amount of ventilation, ventilation hour It does not include the amount of combustion air volume. Dangerous operating room and the like between the gas regulator, the amount of ventilation per hour, should be less than 3 times, when not meet the requirements natural ventilation, mechanical ventilation should be provided, and should be less than 8 air changes per hour accident ventilation times. Fuel pump and reservoir 45 ℃ flash point less than the underground tank of combustible oil, except that natural ventilation, the fuel pump mechanical ventilation 10 air changes per hour should times, six times per hour ventilation should depot mechanical ventilation. The above three are in each room in order to ensure exclusion of air and flammable hydrocarbon disposed a predetermined minimum ventilation rate.

Solid chars produced in the initial stages of combustion of biomass fuels are of very low density. Conservative selection of furnace section size is used to reduce gas velocity and keep char entrainment into the flue gases and possibly out the stack at acceptable levels. Biomass fired steam 100ton liquefied petroleum boiler in the philippines has won many national patents and prizes in China.

As one of Beijing's air pollution emission standards of the most demanding urban, environmental control is very strict. Beijing primary school campus Emerald City as one of the cradles of socialist culture successor, in terms of the quality of students' learning environment is put emphasis on one hundred percent. October 2017, Beijing primary school campus Emerald City with my company, signed a two Thalia T6 series vacuum hot water 100ton liquefied petroleum boiler in the philippines for winter heating use.

3, coal combustion 100ton liquefied petroleum boiler in the philippines technology

This technique is performed by coal-fired boilers, pulverized coal amount to be injected into the furnace in place, so that the combustion grate base layer, an appropriate amount of the suspension increases combustion energy can be obtained a certain rate. As for boiler fuel, gas type, you can replace the old with the new energy-saving burner, behind the burner to be transformed.