8t Natural Gas boiler Fully Automatic Myanmar

Boilers which are several general, in what is now the mainstream Why? 1, gas 8t boiler fully automatic myanmar advantages: efficient, clean, environmentally friendly, without manual operation, only need to monitor, small footprint, no transportation fuel, no need to deal with soot, due to the combustion of natural gas free of impurities, without corrosion damage to the boiler and related accessories long boiler life, defined as 15 years, but basically long-term use. Is now mainstream boiler, natural gas is the environmental protection sector, the government vigorously promoted. Cons: You do not know how much that gas prices are calculated according to the calorific value and thermal efficiency, generally bituminous coal per ton of coal (according to 5500 kcal / kg) is approximately equal to 350 to 400 cubic meters of gas. Probably a little slightly more expensive than coal. (No transport, area, ash handling, labor, etc. into the calculation). 2, oil-fired boiler, advantages: substantially the same structure and properties of gas boilers. Disadvantages: higher cost of natural gas is 2 times the boiler, diesel transportation, storage more dangerous, accident-prone. And the domestic diesel supply is unstable, easily interrupted. 3, coal-fired boilers, the advantages: the economy. Disadvantages: 1, requires a lot of ash and coal yard area. 2, a boiler fireman for 4 to 8 people. 3, boiler room and coal yard is very dirty. 4, noise, emissions of dust, nuisance. 5, environmental protection departments often to check an inattentive, he was diagnosed with excessive emissions, maintenance shutdown, fine, very troublesome. 6, coal sulfur content are more severe corrosion of boiler, 10 to 15 years after the basic unusable. Summary: Due to high oil prices and supply unstable now, and now oil-fired boiler has been temporarily withdrawn from the market. Natural gas prices due to regional differences are very different, although you are not sure where the price of natural gas, but natural gas in most parts of the domestic coal is relatively expensive, (only in Sichuan, northwest of cheaper natural gas). Especially large industrial boilers, more fuel, the cost difference is more obvious. Coal-fired boilers to heavy air pollution, with the country on environmental issues more and more attention, more stringent emission requirements for coal-fired boilers, a lot of urban cities, has stopped the examination and approval procedures coal-fired boilers. It is recommended that, if your organization is not large tonnage production of boilers, installation of gas boilers or better, although with a little more than fuel costs, but in the actual operation of the process, you can save a lot of things, while saving area, the environment is clean.

1, the safety valve should be mounted vertically in a high position in the pot business, set box.

2, between the safety valve and the drum or header, not equipped with access to the steam outlet pipe and the valve.

3, the lever-type safety valve should prevent movement of the self-apparatus and the weight limit leverage deviant guide tube, a spring safety valve should lift and handle means for preventing movement of the adjustment screw is screwed lightly.

4, the rated steam pressure less than or equal to 3.82MPa gas steam boiler safety valve throat diameter of not less than 25mm; power greater than the rated steam pressure 3.82MPa boiler safety valve throat diameter not less than 20mm.

5, the safety valve and coal-fired steam boiler tubes, the cross-sectional area not less than the cross-sectional area of ​​the valve inlet. If several valves installed together with a short tube directly connected to the drum, the cross-sectional area of ​​the passage should not step short tube to 1.25 times the area of ​​all the exhaust valve.

6, the safety valve should normally be installed exhaust pipe, exhaust pipe should be through a safe place, and there is sufficient cross-sectional area to ensure the smooth flow of exhaust.

7, the safety valve exhaust pipe at the bottom should have received a place of safety posturing of drainage pipe, the exhaust pipe and drainage pipe not allow the installation of the valve.

8, rated evaporation to 0.5t h coal-fired steam boiler /, at least two safety valves installed; Rated evaporation 0.5t h less than or equal to electric boiler /, mounted on at least a safety valve.

People's Republic of Bangladesh is the world's largest exporter of jute, a long time for the world transport a large paper stock. Is also an important market, "along the way" important strategic fulcrum of China's industrial and manufacturing. Fang fast Group as an international brand 8t boiler fully automatic myanmar, April 10, the warm reception from distant friends -? Bangladesh PolockGroup Group CEO, Mr Mahbubul Alam Biddut??.

The difference of fuel between Oil-fired Boiler and Gas-fired BoilerOil-fired 8t boiler fully automatic myanmar refers to the fuel-fired boiler, including diesel oil, waste oil and other oil boilers. The overall arrangement of the oil-fired boiler is similar to that of the coal-fired boiler, except that the bottom of the furnace of the oil-fired boiler is mostly made into the bottom of the insulation furnace with a tilt to the back wall of 10 °~ 30 °, in order to obtain good combustion characteristics. In order to atomize fuel oil, there are two types of fuel burner nozzle: mechanical centrifugal injector and steam atomized Y type injector. The fuel of the oil-fired boiler is the fuel (such as diesel oil, kerosene, etc.). The fuel of the gas-fired boiler is gas (such as natural gas, city gas, biogas, etc.), depending on what fuel the boiler burns. The difference between a fuel-fired boiler and a gas-fired boiler is what kind of fuel burners are used to burn the gas-fired boilers, which are called gas-fired boilers, oil-fired boilers with fuel-fired burners, and oil-fired boilers called oil-fired boilers.