6t Natural Gas boiler High Efficiency Thailand

Biomass fired 6t boiler high efficiency thailand fuel characteristics

Biomass fuel has the following main characteristics compared to coal:

1. Low sulfur content. Biomass fuels are mostly less than 0.2% sulphur, and there is no need to install a gas desulfurization device when burning, which reduces costs and is environmentally friendly.

2. Most of the carbon in the biomass fuel combines with hydrogen to form a low-molecular hydrocarbon. After a certain temperature, it thermally decomposes and folds out the volatiles. Therefore, biomass fuel is easily ignited,

3. The density is small. The density of biomass fuel is obviously lower than that of coal, and the texture is relatively loose, especially crop straw, which is bulky.

4. Less carbon. The highest carbon content in biomass fuels is only about 50%, which is equivalent to the carbon content of lignite with less generation.

5. Straw biomass contains a large amount of alkali metal elements (mainly potassium and sodium). In the combustion process of biomass, the main performance is that the adhesion of ash is strong, and slagging and clogging are likely to occur in the furnace. Ash accumulates on the heated surface of the tail.

Subsequently, the delegation visited the company's 6t boiler high efficiency thailand cleaning laboratory, technicians demonstrated to the delegation of the company's latest product boiler operation, and use of DCS control system in the laboratory trace data. Mr. Liu to our boiler products to achieve nitrogen oxide (referred to as NOx) emissions below 18 mg or less, is widely used in Beijing APEC venue, the Central Authority and other countries prefix institutions and other international occasions expressed a high degree of praise and encourage.

A number of factors cause the pressure of the heat efficiency of the 6t boiler high efficiency thailand module are carrying substantially all parts of the coal gas impressive work, use a large extent, avoided the module boiler fouling contamination, while discharging hazardous gas like nitrogen oxides obtained a clamp. Thermal efficiency is an important measure of the rule module boiler, let us study the cause of a number of factors under the pressure of the thermal efficiency of the boiler module. After inquire about the personnel, boiler heat loss module is mainly produced in the bear on these two: the proportion of full combustion air with smoke emission unreasonable heat loss. Reduce smoke emission install heat loss can be recovered in the flue gas waste heat boiler module terminal fitting, or use more advanced features of FGR boiler. The combustion air fully proportional unreasonable non-compliant analysis: General ejector module boiler burner, causing the air-fuel ratio is no way to maneuver to mobilize. Part of the boiler module using a mechanical blower burner, resulting in unreasonable cause fuel ratio factors are the following: the main air-fuel ratio unreasonable encompass divided into two cases: when oxygen is excessive, the excess will be numerous cold is heated, resulting in increased cost of energy boiler module, the thermal efficiency of the boiler module lowered; when oxygen is non-compliance, will produce incomplete combustion occurs module boiler heat efficiency is lowered.

8 large gas 6t boiler high efficiency thailand Safety Precautions: country increasingly stringent air pollution emission standards, an avalanche of environmental policy, the country has already started action boiler "from coal to gas," the elimination of polluting coal-fired boilers to switch to clean green gas boiler. Here, the fast boiler warm to remind you: must pay attention to the eight large gas boiler safe handling. 1, the burner start-up, if the burner repeat alarm lock, you need to immediately identify the reasons for the failure to identify and eliminate then press the reset button, continue to boot.