High Efficiency 6t Agent boiler Armenia

The method of starting the high efficiency 6t agent boiler armenia during boiler startup control drum wall temperature difference of the process to be controlled in a predetermined drum wall temperature difference may take the following measures within 40 ℃: (1) water temperature before ignition can not be too high, not too fast speed, according to rules of execution. (2) water is completed, the bottom may be put into steam heating conditions. (3) strictly control the raising rate, in particular 0 ~ 0.981MPa boosting speed stage should be less than 0.014MPa / min. Rate of temperature rise not greater than 1.5 ~ 2 ℃ / min. (4) should be regularly switching angle oil gun, until the next row when four full cast oil gun, each part as far as possible evenly heated. (5) via the above-described operation can not effectively control the drum, the lower wall temperature, then when the approach or reach 40 ℃ booster should be suspended, and the sewage regularly, in order to enhance the circulating water, and stabilized until the temperature difference is less than 40 ℃ line boost.

The coal-fired water tube steam high efficiency 6t agent boiler armenia water flows in the tube, and by absorbing heat, the water temperature is continuously increased to produce steam.

We can see from the above equation, it must be reduced in order to achieve fuel savings Q3 loss of incomplete combustion, and heat loss due to heat q4 q5. Among them, heat losses q5 that is where the greatest energy loss, and most have a recycling value. To make full use of the energy produced by combustion of the fuel, it is necessary to minimize the exhaust gas temperature. However, reducing the exhaust gas temperature in the actual operation of the high efficiency 6t agent boiler armenia will produce such a large amount of condensed water, causing corrosion to the boiler thereby shortening the life of the boiler.

Inside the Fangkuai high efficiency 6t agent boiler armenia plant, there is a special corrugated furnace bladder production line, which can be processed according to the computer setting mode. At the same time, this is also a unique processing technology of Fangkuai Boiler. The cost of natural gas fuel alone exceeds 5 million yuan per year. The corrugated furnace liner fired by this production line can not only increase the heating surface of the boiler, but also alleviate the damage caused by the thermal expansion and contraction to the combustion chamber, and greatly extend the service life of the boiler.