drying natural gas hot water vacuum water tube boiler

Different types of fuel boilers vacuum phase transition characteristics of the current vacuum phase transition boilers can be classified according to different forms of fuel, this method is easier for people to select and purchase. With increasing depth of industrialization and people's needs, the market share of vacuum phase transition boiler is increasing. Characteristics of different types of vacuum phase transition boiler determines its optimum position. Based on this situation, we should be aware of the classification and various other functions, therefore, the right choice. We will discuss the characteristics of vacuum phase transition boilers of different types. Different types of fuel vacuum phase transition phase transition characteristics of the boiler vacuum boiler may also be referred to as a vacuum boiler. Its working principle is vacuum phase transition and phase change. The fuel can be divided into four categories, but can be divided into three categories and a category, it can be divided into two categories, and describes the characteristics of each fuel. (A) an electrically heated boiler vacuum phase transition phase transition in the electric vacuum heating boiler in operation, the vacuum in the internal environment. Since the electric vacuum phase transition boiler water will be discharged to the outside of the oxygen-containing, oxidative corrosion of the boiler does not cause damage to the device. Meanwhile, the electric hot water boiler heat exchanger portion of the vacuum made of stainless steel does not corrode. Further, only one electric vacuum hot water boiler heat medium plus a small amount of water, does not increase or decrease the run, no fouling. (B) fuel (gas / coal) boilers vacuum phase transition phase transition such a vacuum inlet boiler burners, high combustion efficiency, low noise and emissions. Internal stainless steel heat exchanger, on the one hand to ensure that the heat transfer efficiency, on the other hand to ensure that the clean water. Meanwhile, also equipped with a spiral spoiler, improve the heat transfer efficiency and reduce operating costs. Further, a square structure, boilers and heat exchangers designed as compact structure, small volume.

It provides fast side of boiler equipment, installation and commissioning after all normal, we immediately put into use, the hotel did not delay the normal heating. Meanwhile boiler capacity, energy efficient, fully able to meet the needs of heating and bathing water in our hotel rooms. --customer feedback

Large-scale thermal and thermal power plants can be built in industrial concentrated areas, large and medium-sized cities with large heating loads can be built in northern large and medium-sized cities, operating according to cogeneration of heat and power in heating season and condensing steam mode in non-heating season. In the case of condensing units, heat supply can be achieved by means of low vacuum operation of condenser or drilling and pumping steam in the connecting tube of high and low pressure cylinder of steam turbine, and remarkable energy-saving effect can be obtained.

What are the advantages of vacuum boilers?

Because the inside of the furnace is a vacuum, the heat medium condenses onto the heat exchanger after it is heated and evaporated, so the heating medium is no more than the heating medium in the process of use. At the same time, it is more energy-saving and environmental-friendly than other types of boilers. Do you know what are the main advantages of the most reliable vacuum boiler? Here is a brief introduction to the advantages of vacuum boilers.

1, high efficiency and energy saving because the vacuum negative pressure hot water technology is used in the production design of the vacuum boiler, so it can make the boiler run in the vacuum state, and its boiling point is low, and it can carry on the latent heat exchange of vaporization (condensation latent heat). And using the three-way wet back design, the heat transfer performance is good and can effectively improve the radiation and convection heat transfer area, so it is more efficient and energy-saving.

2, multi-purpose because vacuum boilers are not only divided into vertical, horizontal, fuel and gas and many other models that are freely available to the user, but also because its heat exchanger and header are a separate state. Therefore, the load of heating water and hot water can be switched at any time according to the actual needs, which can fully meet the different requirements of users for heating water and clean hot water, and ensure that hot water is clean and stable so as to realize multi-use of one machine.

3, the installation is simple because the vacuum boiler is manufactured with modular design and high-performance heat transfer components, so the unit size of the boiler is smaller. It is not only convenient for transportation and storage, but also simpler and more convenient in installation method. In addition, it can also be conveniently installed in a small space or can be used in parallel operation of multiple units according to the actual needs. These three parts are the main advantages of vacuum boilers.