Distributor 1t Natural Gas boiler Cambodia

Coal-fired distributor 1t boiler cambodias to gas boilers benefits and precautions With the rapid development of national energy-saving environmental protection, the traditional coal-fired boiler can not meet the needs of the times. Therefore, the coal-fired boiler biomass boiler or gas boiler has become in many boiler user's choice. Before the transformation, to understand the difference between .1 and gas boiler fired boiler. Circulating fluidized bed combustion boiler fired by coal crushing device fluidized combustion process, the coal by crushing device percutaneously into the bunker through a the spreading coal coal injecting air into the furnace; circulating ash by heating, fluidized combustion process. When the coal into a gas fuel is injected directly into the combustor for combustion. 2. Combustion of Coal is mainly composed of C, H, O, N, S, ash and moisture and other elements. Generated when coal SO2, SO3, NOx ash and moisture, and SO2, SO3, NOx from flue gas emitted into the atmosphere, pollute the environment and cause harm to humans. The main components of the exhaust gas and coke are CO and H2. The main produce CO2 and H2 post-combustion, much lower than coal-fired boiler SO2, SO3 and NOX emissions. 3. Ventilation pressurized combustion coal combustion boiler used in a combustion mode. The bottom of the combustion process through the induced draft fan with fan and completed. In the combustion of coal, it requires a lot of air. Gas under a slight positive pressure in the boiler or burner slightly negative pressure, which requires less airflow. Burner air may be pre-mixed with natural gas. 4. coal boiler control reasons, material thickness, amount of wind, the wind volume, wind and other than coal, coal-fired boiler is difficult to automatically adjust the operating parameters of the boiler according to the load. However, fewer factors gas boiler, the burner valve can be adjusted according to the size of the load, easy to implement automatic control. Coal-fired boiler to a gas boiler Notes: Main results are as follows: (1) small boiler, the coal-fired boiler to a gas boiler, i.e. the negative pressure of combustion from the original to the current combustion slight positive pressure, and must pay attention to the furnace wall structure sealing problems. Closely related (2) selection and arrangement of the burner and furnace, the degree of filling of the flame in the furnace is preferably not formed dead air, to avoid the interference of adjacent flame burners, to avoid interference from adjacent burner flame. Unburned gas - air mixture should not be in contact with a heated surface, in order to avoid incomplete combustion. Gas combustion. Gas burner arrangement disposed conduit and ducts should be considered reasonable gas pipe and duct arrangement, ease of operation, inspection and maintenance. (3) the transformation of coal-fired boilers is mechanized layered gas boiler should be removed before the arch and the arch, and the bottom heating surface increases, in place of the grate, the grate to prevent overheating. Gas Velocity (4) on heat transfer surface of the fly ash is not restricted abrasion conditions, convection heating surface heat transfer coefficient is increased, increasing the pressure in the boiler where H is unduly increased. Boiler erosion surface. At this time, the capacity of the boiler should be noted that the steam separator to ensure the quality of the steam.

Gas oil furnace gas consumption and related questions can automate operations: conducting oil furnace oil furnace gas this kind, it is also the product website and keywords, it is necessary to know and understand the subject, otherwise, can not be familiar with the site and its manufacturer. Therefore, in order to achieve this goal, the following will be introduced to the product description, so that we have to learn content, and thus, can be development and progress in their learning path. 12 000 kcal conducting oil furnace gas, if gas is natural gas which, then, the upper limit of the distributor 1t boiler cambodia air consumption of natural gas, how much is? 200,000 kcal conducting oil furnace gas, if it is natural gas, then, the air consumption of the boiler gas limits are as follows: 200,000 divided by the gas heating value and thermal efficiency of the boiler, so as to obtain a particular value . If the boiler thermal efficiency is 94.8%, then, is the specific results of 24.8 cubic meters / h.

Calculated gas steam distributor 1t boiler cambodia plant to explain your boiler heating area: Gas-fired steam boiler plant to you to explain the calculation method of gas steam boiler heating area of ​​the boiler, which is sure to install emissions-line monitoring devices, and, should environmental protection department of the monitoring center networking, so the job. And this kind of boiler heating area, specifically, then, is to be determined according to the location of the boiler, its usage and requirements. Generally speaking, if it is 1 ton, then, it is about 7000 square meters of heating area. 4 tons of gas steam boiler, which uses induced draft fan, then, that in the selection and configuration, generally speaking, if a different motor, then, there is a different choice, but specifically, then, is there are two First, Y5-47-6C, power is 15KW / 18.5kw, grade 2 is a motor; Second Y6-41-7.1C, power is 15kw / 18.5kw, the motor is four. 10 tons of gas steam boiler, between it and the workshop is to have a safe distance, and can not be a piece design, it must be independent. Therefore, it is generally to be more than 5 meters, so the job, however, can also be separated coal field.

On January regular press conference, Secretary, Ministry of Environment environment atmosphere Liu Bingjiang said: Through the joint efforts of the whole society, national ambient air quality is generally improving. But issues of current emissions of air pollutants is still high, industry structure, energy structure is still prominent, air pollution control remains to be done.

2019 is to win the battle of the blue sky in tackling it. China Environmental Science Research Institute Professor Xue Zhigang said China is still partial to change the energy mix of coal to Beijing and Tianjin, for example, though not local, but coal consumption per unit area of ​​5 to 6 times the national, so to adhere to focus total coal consumption areas under control.

First, the structure of coal-based energy, coal pollution characteristics significantly. Shaanxi, Shanxi coal-producing province is also the province's coal consumption, coal consumption Fenwei plain more focused, coal accounted for nearly 90% of energy consumption, much higher than the national average of 60%.

Second, the emphasis on regional industrial structure, industrial pollution emissions from large. Fenwei plain alumina, coke, iron and steel, coal, chemical and other heavy chemical industry, small-scale enterprises, low level of equipment, and most enterprises have yet to achieve a stable discharge standards, ultra-low emission completion percentage less than the transformation of thermal power enterprises in Beijing, Tianjin the level of pollution control needs to be improved.

Third, the prominent road transport pollution, emissions from large heavy vehicles. Fenwei plain is an important channel Shaanxi, Inner Mongolia and Shanxi coal Sinotrans, common to road transport, heavy industry-oriented industrial structure to further increase the pressure of road transport.

Hebei Province in 2019 government work report, determined to win the battle of the blue sky, ultra-low emissions to accelerate the transformation of key industries and promote clean coal casual alternative, "scattered dirt" dynamic business continuity cleared, Hebei Province, the year will be 10 million tons of coal Yajian thermal power 500,000 kilowatts.

Tianjin in 2019 to promote low-nitrogen transformation and construction work clean diesel transformation of mechanical gas-fired boilers, in an orderly urban and rural residents clean alternative to coal for heating, PM2.5年均浓度持续下降. In addition, Guizhou, Gansu, Heilongjiang and other places have made the coal control target.

It is reported that, after the heating season this year, the Ministry of Environment will work with ecological scientific and reasonable arrangements around 2019 bulk coal management plan. Regional authorities will further strengthen joint prevention and control, continue to implement the autumn and winter tackling action in key areas. In the future, China will focus on promoting the Beijing and Tianjin and the surrounding areas, as well as bulk coal governance Fenwei plains, to the 2020 heating season, the basic completion of the plains to live and bulk coal for heating in winter instead.